APRS Track Direct

My position About ☰

reset

BU2GE-3 Telemetry

This is the latest recevied telemetry packets stored in our database for station/object BU2GE-3. If no packets are shown the sender has not sent any telemetry packets the latest 1 day(s).

Telemetry packets is used to share measurements like repeteater parameters, battery voltage, radiation readings (or any other measurements).

<< 1 2 >>

Time	CPUTemp*	DiGi*
1732297662	27.5 C	987 p
1732296462	27.3 C	979 p
1732295263	27.4 C	973 p
1732294062	28 C	967 p
1732292862	28.5 C	959 p
1732291662	27.1 C	953 p
1732290462	28.1 C	946 p
1732289262	27.6 C	938 p
1732288062	27.4 C	933 p
1732286862	27.6 C	926 p
1732285663	27.6 C	916 p
1732284462	27.6 C	911 p
1732283261	28.1 C	903 p
1732282062	28.5 C	895 p
1732280862	27.6 C	890 p
1732279661	28.1 C	883 p
1732278462	28 C	876 p
1732277264	27.5 C	870 p
1732276062	27.9 C	862 p
1732274863	28.6 C	855 p
1732273664	28.6 C	849 p
1732272462	28.9 C	841 p
1732271262	29.3 C	830 p
1732270063	28.3 C	818 p
1732268862	28.8 C	799 p

*Used Equation Coefficients:

CPUTemp: 0, 1, 0

RxPkts/20m: 0, 1, 0

RxPkts/1h: 0, 1, 0

RxPkts/24h: 0, 1, 0

DiGi: 0, 1, 0

The parameter names for the analog channels will be Value1, Value2, Value3 (up to Value5) if station has not sent a PARAM-packet that specifies the parameter names for each analog channel.
Each analog value is a decimal number between 000 and 255 (according to APRS specifications). The receiver use the telemetry equation coefficientsto to restore the original sensor values. If no EQNS-packet with equation coefficients is sent we will show the values as is (this corresponds to the equation coefficients a=0, b=1 and c=0).
The sent equation coefficients is used in the equation: a * value² + b * value + c.
The units for the analog values will not be shown if station has not sent a UNIT-packet specifying what unit's to use.
The parameter names for the digital bits will be Bit1, Bit2, Bit3 (up to Bit8) if station has not sent a PARAM-packet that specifies the parameter names for each digital bit.
All bit labels will be named "On" if station has not sent a UNIT-packet that specifies the label of each bit.
A bit is considered to be On when the bit is 1 if station has not sent a BITS-packet that specifies another "Bit sense" (a BITS-packet specify the state of the bits that match the BIT labels)