APRS Track Direct

My position About ☰

reset

DTSERO Telemetry

This is the latest recevied telemetry packets stored in our database for station/object DTSERO. If no packets are shown the sender has not sent any telemetry packets the latest 1 day(s).

Telemetry packets is used to share measurements like repeteater parameters, battery voltage, radiation readings (or any other measurements).

<< 1 2 3 4 >>

Time	Value1*	Value2*	Value3*	Value4*	Value5*
1836274365	128	26	69	65	48
1836274215	127	27	71	41	48
1774149397	127	29	68	41	48
1774148797	127	33	70	41	48
1774148195	127	27	70	41	48
1774146395	127	26	69	41	48
1774145796	127	29	69	41	49
1774145196	127	33	70	41	48
1774144594	127	29	98	42	74
1774143993	127	28	97	41	48
1774143393	128	26	69	41	48
1774142793	128	27	69	41	48
1774142192	127	27	68	41	48
1774141592	127	27	68	42	48
1774140992	127	27	69	41	49
1774140391	128	24	68	41	48
1774138591	129	26	68	41	48
1774137989	129	29	67	66	49
1774137390	130	28	69	41	48
1774136790	132	29	68	41	48
1774136193	133	26	94	42	48
1774135590	133	28	66	41	49
1774134989	135	23	65	41	48
1774134384	135	26	65	41	48
1774133775	134	25	64	41	48

*Used Equation Coefficients:

Value1: 0, 1, 0

Value2: 0, 1, 0

Value3: 0, 1, 0

Value4: 0, 1, 0

Value5: 0, 1, 0

The parameter names for the analog channels will be Value1, Value2, Value3 (up to Value5) if station has not sent a PARAM-packet that specifies the parameter names for each analog channel.
Each analog value is a decimal number between 000 and 255 (according to APRS specifications). The receiver use the telemetry equation coefficientsto to restore the original sensor values. If no EQNS-packet with equation coefficients is sent we will show the values as is (this corresponds to the equation coefficients a=0, b=1 and c=0).
The sent equation coefficients is used in the equation: a * value² + b * value + c.
The units for the analog values will not be shown if station has not sent a UNIT-packet specifying what unit's to use.
The parameter names for the digital bits will be Bit1, Bit2, Bit3 (up to Bit8) if station has not sent a PARAM-packet that specifies the parameter names for each digital bit.
All bit labels will be named "On" if station has not sent a UNIT-packet that specifies the label of each bit.
A bit is considered to be On when the bit is 1 if station has not sent a BITS-packet that specifies another "Bit sense" (a BITS-packet specify the state of the bits that match the BIT labels)