APRS Track Direct

My position About ☰

reset

XE2AD-15 Telemetry

This is the latest recevied telemetry packets stored in our database for station/object XE2AD-15. If no packets are shown the sender has not sent any telemetry packets the latest 1 day(s).

Telemetry packets is used to share measurements like repeteater parameters, battery voltage, radiation readings (or any other measurements).

<< 1 2 >>

Time	TX*	RX*	Digi*
1790637428	89 Count	160 Count	82 Count
1790635624	78 Count	141 Count	72 Count
1790633820	70 Count	131 Count	65 Count
1790632017	52 Count	100 Count	48 Count
1790630214	41 Count	88 Count	38 Count
1790628410	39 Count	79 Count	37 Count
1790624803	11 Count	23 Count	11 Count
1790616995	797 Count	976 Count	664 Count
1790615191	796 Count	975 Count	664 Count
1790613388	792 Count	969 Count	661 Count
1790611584	787 Count	962 Count	657 Count
1790609781	782 Count	957 Count	653 Count
1790607978	781 Count	957 Count	653 Count
1790606174	780 Count	956 Count	653 Count
1790602568	768 Count	946 Count	643 Count
1790600377	755 Count	937 Count	636 Count
1790596771	735 Count	909 Count	618 Count
1790594968	726 Count	900 Count	610 Count
1790593164	721 Count	893 Count	606 Count
1790589556	710 Count	881 Count	597 Count
1790587752	705 Count	875 Count	593 Count
1790585949	701 Count	869 Count	590 Count
1790584145	696 Count	862 Count	586 Count
1790582342	690 Count	855 Count	581 Count
1790578773	672 Count	838 Count	569 Count

*Used Equation Coefficients:

TX: 0, 1, 0

RX: 0, 1, 0

Digi: 0, 1, 0

V_Bat: 0, 0.01, 0

V_Ext: 0, 0.02, 0

The parameter names for the analog channels will be Value1, Value2, Value3 (up to Value5) if station has not sent a PARAM-packet that specifies the parameter names for each analog channel.
Each analog value is a decimal number between 000 and 255 (according to APRS specifications). The receiver use the telemetry equation coefficientsto to restore the original sensor values. If no EQNS-packet with equation coefficients is sent we will show the values as is (this corresponds to the equation coefficients a=0, b=1 and c=0).
The sent equation coefficients is used in the equation: a * value² + b * value + c.
The units for the analog values will not be shown if station has not sent a UNIT-packet specifying what unit's to use.
The parameter names for the digital bits will be Bit1, Bit2, Bit3 (up to Bit8) if station has not sent a PARAM-packet that specifies the parameter names for each digital bit.
All bit labels will be named "On" if station has not sent a UNIT-packet that specifies the label of each bit.
A bit is considered to be On when the bit is 1 if station has not sent a BITS-packet that specifies another "Bit sense" (a BITS-packet specify the state of the bits that match the BIT labels)