APRS Track Direct

My position About ☰

reset

IR3ZWY-1 Telemetry

This is the latest recevied telemetry packets stored in our database for station/object IR3ZWY-1. If no packets are shown the sender has not sent any telemetry packets the latest 1 day(s).

Telemetry packets is used to share measurements like repeteater parameters, battery voltage, radiation readings (or any other measurements).

<< 1 2 >>

Time	Value1*	Value2*	Value3*	Value4*	Value5*
1745035005	238	153	2	361	61
1745034705	225	152	1	361	61
1745034404	249	153	1	361	61
1745034104	249	152	0	361	61
1745033804	234	150	0	361	61
1745033504	223	149	2	361	61
1745033203	240	148	2	361	61
1745032903	217	147	1	361	61
1745032603	227	148	1	361	61
1745032302	246	150	1	361	61
1745032002	208	150	1	361	61
1745031702	212	152	1	361	61
1745031401	235	152	1	361	61
1745031101	239	154	2	361	61
1745030801	213	152	2	361	61
1745030501	233	155	0	361	61
1745030200	210	155	0	361	61
1745029900	193	155	1	361	61
1745029600	245	155	1	361	61
1745029299	248	156	0	361	61
1745028999	246	154	1	361	61
1745028699	260	152	4	361	61
1745028399	241	152	4	361	61
1745028098	232	151	0	360	61
1745027798	236	150	0	360	61

*Used Equation Coefficients:

Value1: 0, 1, 0

Value2: 0, 1, 0

Value3: 0, 1, 0

Value4: 0, 1, 0

Value5: 0, 1, 0

The parameter names for the analog channels will be Value1, Value2, Value3 (up to Value5) if station has not sent a PARAM-packet that specifies the parameter names for each analog channel.
Each analog value is a decimal number between 000 and 255 (according to APRS specifications). The receiver use the telemetry equation coefficientsto to restore the original sensor values. If no EQNS-packet with equation coefficients is sent we will show the values as is (this corresponds to the equation coefficients a=0, b=1 and c=0).
The sent equation coefficients is used in the equation: a * value² + b * value + c.
The units for the analog values will not be shown if station has not sent a UNIT-packet specifying what unit's to use.
The parameter names for the digital bits will be Bit1, Bit2, Bit3 (up to Bit8) if station has not sent a PARAM-packet that specifies the parameter names for each digital bit.
All bit labels will be named "On" if station has not sent a UNIT-packet that specifies the label of each bit.
A bit is considered to be On when the bit is 1 if station has not sent a BITS-packet that specifies another "Bit sense" (a BITS-packet specify the state of the bits that match the BIT labels)