APRS Track Direct

My position About ☰

reset

KENDAL Telemetry

This is the latest recevied telemetry packets stored in our database for station/object KENDAL. If no packets are shown the sender has not sent any telemetry packets the latest 1 day(s).

Telemetry packets is used to share measurements like repeteater parameters, battery voltage, radiation readings (or any other measurements).

<< 1 2 >>

Time	Value1*	Value2*	Value3*	Value4*	Value5*
1786749011	134	27	64	42	48
1786747185	133	30	63	41	48
1786745354	137	31	63	41	48
1786743523	133	26	64	41	48
1786741701	142	40	66	41	48
1786739874	132	51	64	42	48
1786738040	132	36	63	42	48
1786736214	135	14	59	41	48
1786734385	137	33	61	41	48
1786732567	133	75	61	41	48
1786730737	133	28	61	41	48
1786728912	134	64	61	42	48
1786727079	139	35	64	42	48
1786725255	142	29	65	41	48
1786723424	140	28	67	41	48
1786721594	131	35	68	41	48
1786719761	125	31	71	51	48
1786717918	124	25	70	41	48
1786716086	124	33	70	41	48
1786714251	111	0	56	42	48
1786712422	123	30	90	42	74
1786710595	123	60	66	41	48
1786708762	123	29	68	41	48
1786706930	124	29	68	41	48
1786705097	124	30	70	41	48

*Used Equation Coefficients:

Value1: 0, 1, 0

Value2: 0, 1, 0

Value3: 0, 1, 0

Value4: 0, 1, 0

Value5: 0, 1, 0

The parameter names for the analog channels will be Value1, Value2, Value3 (up to Value5) if station has not sent a PARAM-packet that specifies the parameter names for each analog channel.
Each analog value is a decimal number between 000 and 255 (according to APRS specifications). The receiver use the telemetry equation coefficientsto to restore the original sensor values. If no EQNS-packet with equation coefficients is sent we will show the values as is (this corresponds to the equation coefficients a=0, b=1 and c=0).
The sent equation coefficients is used in the equation: a * value² + b * value + c.
The units for the analog values will not be shown if station has not sent a UNIT-packet specifying what unit's to use.
The parameter names for the digital bits will be Bit1, Bit2, Bit3 (up to Bit8) if station has not sent a PARAM-packet that specifies the parameter names for each digital bit.
All bit labels will be named "On" if station has not sent a UNIT-packet that specifies the label of each bit.
A bit is considered to be On when the bit is 1 if station has not sent a BITS-packet that specifies another "Bit sense" (a BITS-packet specify the state of the bits that match the BIT labels)