APRS Track Direct

My position About ☰

reset

SP2OSA Telemetry

This is the latest recevied telemetry packets stored in our database for station/object SP2OSA. If no packets are shown the sender has not sent any telemetry packets the latest 1 day(s).

Telemetry packets is used to share measurements like repeteater parameters, battery voltage, radiation readings (or any other measurements).

<< 1 2 >>

Time	TX*	RX*	Digi*
1791762848	8 Count	337 Count	2 Count
1791761047	6 Count	224 Count	1 Count
1791759246	5 Count	117 Count	1 Count
1791757453	19 Count	1052 Count	11 Count
1791753852	16 Count	827 Count	10 Count
1791752051	14 Count	709 Count	9 Count
1791750250	12 Count	594 Count	8 Count
1791748449	10 Count	502 Count	7 Count
1791746649	8 Count	386 Count	6 Count
1791743047	4 Count	131 Count	4 Count
1791741246	45 Count	1017 Count	36 Count
1791739446	41 Count	852 Count	33 Count
1791737645	38 Count	691 Count	31 Count
1791734051	7 Count	330 Count	6 Count
1791732250	5 Count	181 Count	5 Count
1791730450	65 Count	1099 Count	60 Count
1791728649	42 Count	914 Count	38 Count
1791726848	33 Count	742 Count	30 Count
1791725048	14 Count	553 Count	12 Count
1791723248	9 Count	337 Count	8 Count
1791721446	4 Count	163 Count	4 Count
1791719645	19 Count	1110 Count	9 Count
1791717845	16 Count	936 Count	7 Count
1791716044	14 Count	786 Count	6 Count
1791714251	8 Count	626 Count	5 Count

*Used Equation Coefficients:

TX: 0, 1, 0

RX: 0, 1, 0

Digi: 0, 1, 0

V_Bat: 0, 0.01, 0

V_Ext: 0, 0.02, 0

The parameter names for the analog channels will be Value1, Value2, Value3 (up to Value5) if station has not sent a PARAM-packet that specifies the parameter names for each analog channel.
Each analog value is a decimal number between 000 and 255 (according to APRS specifications). The receiver use the telemetry equation coefficientsto to restore the original sensor values. If no EQNS-packet with equation coefficients is sent we will show the values as is (this corresponds to the equation coefficients a=0, b=1 and c=0).
The sent equation coefficients is used in the equation: a * value² + b * value + c.
The units for the analog values will not be shown if station has not sent a UNIT-packet specifying what unit's to use.
The parameter names for the digital bits will be Bit1, Bit2, Bit3 (up to Bit8) if station has not sent a PARAM-packet that specifies the parameter names for each digital bit.
All bit labels will be named "On" if station has not sent a UNIT-packet that specifies the label of each bit.
A bit is considered to be On when the bit is 1 if station has not sent a BITS-packet that specifies another "Bit sense" (a BITS-packet specify the state of the bits that match the BIT labels)