APRS Track Direct

My position About ☰

reset

YO8PIC-12 Telemetry

This is the latest recevied telemetry packets stored in our database for station/object YO8PIC-12. If no packets are shown the sender has not sent any telemetry packets the latest 1 day(s).

Telemetry packets is used to share measurements like repeteater parameters, battery voltage, radiation readings (or any other measurements).

<< 1 2 3 >>

Time	RSSI*	VBAT*
1786732661	-93 dbm	0.12 V
1786732061	-92 dbm	0.12 V
1786731462	-92 dbm	0.12 V
1786730861	-92 dbm	0.12 V
1786730261	-92 dbm	0.12 V
1786729661	-93 dbm	0.12 V
1786729061	-93 dbm	0.12 V
1786728461	-92 dbm	0.12 V
1786727861	-92 dbm	0.12 V
1786727261	-92 dbm	0.12 V
1786726661	-92 dbm	0.12 V
1786726061	-92 dbm	0.12 V
1786725461	-92 dbm	0.12 V
1786724861	-92 dbm	0.12 V
1786724261	-90 dbm	0.12 V
1786723661	-91 dbm	0.12 V
1786723061	-91 dbm	0.12 V
1786722461	-91 dbm	0.12 V
1786721862	-91 dbm	0.12 V
1786721261	-91 dbm	0.14 V
1786720661	-91 dbm	0.12 V
1786720061	-91 dbm	0.16 V
1786719462	-91 dbm	0.16 V
1786718861	-90 dbm	0.16 V
1786718261	-90 dbm	0.16 V

*Used Equation Coefficients:

RSSI: 0, -1, 0

VBAT: 0, 0.01, 0

Value3: 0, 0, 0

Value4: 0, 0, 0

Value5: 0, 0, 0

The parameter names for the analog channels will be Value1, Value2, Value3 (up to Value5) if station has not sent a PARAM-packet that specifies the parameter names for each analog channel.
Each analog value is a decimal number between 000 and 255 (according to APRS specifications). The receiver use the telemetry equation coefficientsto to restore the original sensor values. If no EQNS-packet with equation coefficients is sent we will show the values as is (this corresponds to the equation coefficients a=0, b=1 and c=0).
The sent equation coefficients is used in the equation: a * value² + b * value + c.
The units for the analog values will not be shown if station has not sent a UNIT-packet specifying what unit's to use.
The parameter names for the digital bits will be Bit1, Bit2, Bit3 (up to Bit8) if station has not sent a PARAM-packet that specifies the parameter names for each digital bit.
All bit labels will be named "On" if station has not sent a UNIT-packet that specifies the label of each bit.
A bit is considered to be On when the bit is 1 if station has not sent a BITS-packet that specifies another "Bit sense" (a BITS-packet specify the state of the bits that match the BIT labels)