APRS Track Direct

My position About ☰

reset

K6QS-1 Telemetry

This is the latest recevied telemetry packets stored in our database for station/object K6QS-1. If no packets are shown the sender has not sent any telemetry packets the latest 1 day(s).

Telemetry packets is used to share measurements like repeteater parameters, battery voltage, radiation readings (or any other measurements).

<< 1 2 3 4 >>

Time	Value1*	Value2*	Value3*	Value4*
1739739871	100	48	2	128
1739738970	100	48	2	128
1739738071	100	48	2	128
1739737629	138	0	0	0
1739737110	100	48	2	128
1739736210	100	48	2	128
1739735310	100	48	2	128
1739734350	100	48	2	128
1739733427	138	0	0	0
1739733390	100	48	2	128
1739732430	100	48	2	128
1739731470	100	48	2	128
1739730570	100	48	2	128
1739729610	100	48	2	128
1739729225	138	0	0	0
1739728650	100	48	2	128
1739727750	100	48	2	128
1739726850	100	48	2	128
1739725950	100	48	2	128
1739725021	138	0	0	0
1739724990	100	48	2	128
1739724030	100	48	2	128
1739723070	100	48	2	128
1739722170	100	48	2	128
1739721270	100	48	2	128

*Used Equation Coefficients:

Value1: 0, 1, 0

Value2: 0, 1, 0

Value3: 0, 1, 0

Value4: 0, 1, 0

Value5: 0, 1, 0

The parameter names for the analog channels will be Value1, Value2, Value3 (up to Value5) if station has not sent a PARAM-packet that specifies the parameter names for each analog channel.
Each analog value is a decimal number between 000 and 255 (according to APRS specifications). The receiver use the telemetry equation coefficientsto to restore the original sensor values. If no EQNS-packet with equation coefficients is sent we will show the values as is (this corresponds to the equation coefficients a=0, b=1 and c=0).
The sent equation coefficients is used in the equation: a * value² + b * value + c.
The units for the analog values will not be shown if station has not sent a UNIT-packet specifying what unit's to use.
The parameter names for the digital bits will be Bit1, Bit2, Bit3 (up to Bit8) if station has not sent a PARAM-packet that specifies the parameter names for each digital bit.
All bit labels will be named "On" if station has not sent a UNIT-packet that specifies the label of each bit.
A bit is considered to be On when the bit is 1 if station has not sent a BITS-packet that specifies another "Bit sense" (a BITS-packet specify the state of the bits that match the BIT labels)