APRS Track Direct

My position About ☰

reset

FW0690 Telemetry

This is the latest recevied telemetry packets stored in our database for station/object FW0690. If no packets are shown the sender has not sent any telemetry packets the latest 1 day(s).

Telemetry packets is used to share measurements like repeteater parameters, battery voltage, radiation readings (or any other measurements).

<< 1 2 3 4 >>

Time	Value1*	Value2*	Value3*	Value4*	Value5*
1744458012	245	72	13	13	32
1744457652	245	72	13	14	35
1744457292	244	72	15	14	37
1744456932	244	72	15	11	28
1744456572	244	72	15	11	27
1744456212	244	72	13	11	27
1744455852	244	72	13	12	30
1744455492	245	72	15	12	31
1744455132	245	71	15	14	36
1744454772	245	81	15	16	40
1744454412	245	71	13	16	40
1744454052	244	73	13	17	43
1744453692	245	75	13	18	45
1744453332	245	73	15	15	39
1744452973	244	75	15	19	48
1744452612	245	77	13	22	55
1744452252	245	77	13	20	50
1744451892	245	73	13	23	59
1744451532	245	75	15	37	91
1744451172	245	77	15	16	41
1744450812	245	75	13	16	40
1744450452	245	77	13	17	44
1744450092	245	76	13	20	50
1744449732	245	76	15	21	52
1744449372	245	76	15	21	52

*Used Equation Coefficients:

Value1: 0, 1, 0

Value2: 0, 1, 0

Value3: 0, 1, 0

Value4: 0, 1, 0

Value5: 0, 1, 0

The parameter names for the analog channels will be Value1, Value2, Value3 (up to Value5) if station has not sent a PARAM-packet that specifies the parameter names for each analog channel.
Each analog value is a decimal number between 000 and 255 (according to APRS specifications). The receiver use the telemetry equation coefficientsto to restore the original sensor values. If no EQNS-packet with equation coefficients is sent we will show the values as is (this corresponds to the equation coefficients a=0, b=1 and c=0).
The sent equation coefficients is used in the equation: a * value² + b * value + c.
The units for the analog values will not be shown if station has not sent a UNIT-packet specifying what unit's to use.
The parameter names for the digital bits will be Bit1, Bit2, Bit3 (up to Bit8) if station has not sent a PARAM-packet that specifies the parameter names for each digital bit.
All bit labels will be named "On" if station has not sent a UNIT-packet that specifies the label of each bit.
A bit is considered to be On when the bit is 1 if station has not sent a BITS-packet that specifies another "Bit sense" (a BITS-packet specify the state of the bits that match the BIT labels)