APRS Track Direct

My position About ☰

reset

BU2GE-3 Telemetry

This is the latest recevied telemetry packets stored in our database for station/object BU2GE-3. If no packets are shown the sender has not sent any telemetry packets the latest 1 day(s).

Telemetry packets is used to share measurements like repeteater parameters, battery voltage, radiation readings (or any other measurements).

<< 1 2 >>

Time	CPUTemp*	DiGi*
1749321421	33.2 C	1261 p
1749320221	33.8 C	1249 p
1749319021	34.2 C	1237 p
1749317821	32.5 C	1206 p
1749316621	32.6 C	1175 p
1749315421	32 C	1160 p
1749314221	33.1 C	1143 p
1749313024	32.7 C	1125 p
1749311822	33.4 C	1106 p
1749310620	33.2 C	1096 p
1749309420	32.7 C	1064 p
1749308220	32.3 C	1052 p
1749307021	33.4 C	1040 p
1749305820	32.6 C	1028 p
1749304621	32.6 C	1017 p
1749302221	33.1 C	993 p
1749301021	33.4 C	977 p
1749299821	32.9 C	960 p
1749298620	32.1 C	950 p
1749297420	32 C	939 p
1749296221	32.3 C	929 p
1749295021	32.1 C	921 p
1749293820	33.1 C	912 p
1749292621	32.1 C	897 p
1749291421	32.8 C	884 p

*Used Equation Coefficients:

CPUTemp: 0, 1, 0

RxPkts/20m: 0, 1, 0

RxPkts/1h: 0, 1, 0

RxPkts/24h: 0, 1, 0

DiGi: 0, 1, 0

The parameter names for the analog channels will be Value1, Value2, Value3 (up to Value5) if station has not sent a PARAM-packet that specifies the parameter names for each analog channel.
Each analog value is a decimal number between 000 and 255 (according to APRS specifications). The receiver use the telemetry equation coefficientsto to restore the original sensor values. If no EQNS-packet with equation coefficients is sent we will show the values as is (this corresponds to the equation coefficients a=0, b=1 and c=0).
The sent equation coefficients is used in the equation: a * value² + b * value + c.
The units for the analog values will not be shown if station has not sent a UNIT-packet specifying what unit's to use.
The parameter names for the digital bits will be Bit1, Bit2, Bit3 (up to Bit8) if station has not sent a PARAM-packet that specifies the parameter names for each digital bit.
All bit labels will be named "On" if station has not sent a UNIT-packet that specifies the label of each bit.
A bit is considered to be On when the bit is 1 if station has not sent a BITS-packet that specifies another "Bit sense" (a BITS-packet specify the state of the bits that match the BIT labels)