APRS Track Direct

My position About ☰

reset

DG1RUE Telemetry

This is the latest recevied telemetry packets stored in our database for station/object DG1RUE. If no packets are shown the sender has not sent any telemetry packets the latest 1 day(s).

Telemetry packets is used to share measurements like repeteater parameters, battery voltage, radiation readings (or any other measurements).

<< 1 2 3 4 >>

Time	Battery*	Rx1h*
1754057779	13.52 Volt	30 Pkt
1754057479	13.52 Volt	29 Pkt
1754057179	13.52 Volt	29 Pkt
1754056879	13.52 Volt	29 Pkt
1754056578	13.52 Volt	27 Pkt
1754056278	13.52 Volt	27 Pkt
1754055978	13.52 Volt	27 Pkt
1754055677	13.52 Volt	27 Pkt
1754055377	13.52 Volt	26 Pkt
1754055077	13.52 Volt	25 Pkt
1754054776	13.52 Volt	24 Pkt
1754054476	13.52 Volt	24 Pkt
1754054176	13.52 Volt	24 Pkt
1754053876	13.52 Volt	23 Pkt
1754053575	13.52 Volt	23 Pkt
1754053275	13.52 Volt	24 Pkt
1754052975	13.52 Volt	25 Pkt
1754052674	13.52 Volt	26 Pkt
1754052374	13.52 Volt	24 Pkt
1754052074	13.52 Volt	24 Pkt
1754051774	13.52 Volt	25 Pkt
1754051473	13.52 Volt	26 Pkt
1754051173	13.52 Volt	26 Pkt
1754050873	13.52 Volt	26 Pkt
1754050572	13.52 Volt	25 Pkt

*Used Equation Coefficients:

Battery: 0, 0.078158, 0

Rx1h: 0, 1, 0

Dg1h: 0, 10, 0

Eff1h: 0, 1, 0

A5: 0, 0, 0

The parameter names for the analog channels will be Value1, Value2, Value3 (up to Value5) if station has not sent a PARAM-packet that specifies the parameter names for each analog channel.
Each analog value is a decimal number between 000 and 255 (according to APRS specifications). The receiver use the telemetry equation coefficientsto to restore the original sensor values. If no EQNS-packet with equation coefficients is sent we will show the values as is (this corresponds to the equation coefficients a=0, b=1 and c=0).
The sent equation coefficients is used in the equation: a * value² + b * value + c.
The units for the analog values will not be shown if station has not sent a UNIT-packet specifying what unit's to use.
The parameter names for the digital bits will be Bit1, Bit2, Bit3 (up to Bit8) if station has not sent a PARAM-packet that specifies the parameter names for each digital bit.
All bit labels will be named "On" if station has not sent a UNIT-packet that specifies the label of each bit.
A bit is considered to be On when the bit is 1 if station has not sent a BITS-packet that specifies another "Bit sense" (a BITS-packet specify the state of the bits that match the BIT labels)