APRS Track Direct

My position About ☰

reset

OK0DV-0 Telemetry

This is the latest recevied telemetry packets stored in our database for station/object OK0DV-0. If no packets are shown the sender has not sent any telemetry packets the latest 1 day(s).

Telemetry packets is used to share measurements like repeteater parameters, battery voltage, radiation readings (or any other measurements).

Time	Value1*	Value2*	Value3*	Value4*	Value5*
1786721639	146	122	114	102	108
1786718939	154	130	122	100	110
1786712039	148	126	118	102	106
1786711140	148	126	118	102	106
1786710840	148	126	118	102	106
1786709640	152	132	120	102	106
1786708740	150	140	112	106	104
1786698841	142	128	104	114	98
1786695241	138	124	100	118	94
1786694941	140	126	100	118	94
1786685943	126	112	90	122	88
1786683542	126	110	88	122	86
1786682042	126	108	88	122	86
1786678142	122	108	86	124	84
1786674542	128	110	86	124	84
1786669143	126	110	86	122	86
1786667343	126	110	88	120	86
1786662001	128	112	90	118	88
1786660435	126	114	90	118	88
1786651736	130	118	92	116	90
1786649936	132	120	92	116	90
1786648137	134	120	96	114	92
1786639737	142	118	112	106	102
1786638537	146	124	114	104	102

*Used Equation Coefficients:

Value1: 0, 1, 0

Value2: 0, 1, 0

Value3: 0, 1, 0

Value4: 0, 1, 0

Value5: 0, 1, 0

The parameter names for the analog channels will be Value1, Value2, Value3 (up to Value5) if station has not sent a PARAM-packet that specifies the parameter names for each analog channel.
Each analog value is a decimal number between 000 and 255 (according to APRS specifications). The receiver use the telemetry equation coefficientsto to restore the original sensor values. If no EQNS-packet with equation coefficients is sent we will show the values as is (this corresponds to the equation coefficients a=0, b=1 and c=0).
The sent equation coefficients is used in the equation: a * value² + b * value + c.
The units for the analog values will not be shown if station has not sent a UNIT-packet specifying what unit's to use.
The parameter names for the digital bits will be Bit1, Bit2, Bit3 (up to Bit8) if station has not sent a PARAM-packet that specifies the parameter names for each digital bit.
All bit labels will be named "On" if station has not sent a UNIT-packet that specifies the label of each bit.
A bit is considered to be On when the bit is 1 if station has not sent a BITS-packet that specifies another "Bit sense" (a BITS-packet specify the state of the bits that match the BIT labels)