APRS Track Direct

My position About ☰

reset

SP2WM-11 Telemetry

This is the latest recevied telemetry packets stored in our database for station/object SP2WM-11. If no packets are shown the sender has not sent any telemetry packets the latest 1 day(s).

Telemetry packets is used to share measurements like repeteater parameters, battery voltage, radiation readings (or any other measurements).

<< 1 2 3 4 >>

Time	TX*	RX*	Digi*
1790658248	444 Count	994 Count	200 Count
1790657347	442 Count	989 Count	199 Count
1790656447	440 Count	983 Count	198 Count
1790655546	437 Count	976 Count	196 Count
1790654645	435 Count	965 Count	195 Count
1790653745	432 Count	955 Count	193 Count
1790652844	430 Count	948 Count	192 Count
1790651943	427 Count	935 Count	190 Count
1790651042	425 Count	927 Count	189 Count
1790650141	422 Count	915 Count	187 Count
1790649240	420 Count	906 Count	186 Count
1790648340	417 Count	898 Count	184 Count
1790647439	415 Count	888 Count	183 Count
1790646538	413 Count	879 Count	182 Count
1790645655	407 Count	873 Count	181 Count
1790644754	405 Count	869 Count	180 Count
1790643855	403 Count	860 Count	179 Count
1790642953	400 Count	852 Count	177 Count
1790642052	398 Count	849 Count	176 Count
1790641151	397 Count	846 Count	176 Count
1790640251	396 Count	846 Count	176 Count
1790639350	394 Count	845 Count	175 Count
1790638449	393 Count	843 Count	175 Count
1790637549	392 Count	842 Count	175 Count
1790636647	390 Count	840 Count	174 Count

*Used Equation Coefficients:

TX: 0, 1, 0

RX: 0, 1, 0

Digi: 0, 1, 0

V_Bat: 0, 0.01, 0

V_Ext: 0, 0.02, 0

The parameter names for the analog channels will be Value1, Value2, Value3 (up to Value5) if station has not sent a PARAM-packet that specifies the parameter names for each analog channel.
Each analog value is a decimal number between 000 and 255 (according to APRS specifications). The receiver use the telemetry equation coefficientsto to restore the original sensor values. If no EQNS-packet with equation coefficients is sent we will show the values as is (this corresponds to the equation coefficients a=0, b=1 and c=0).
The sent equation coefficients is used in the equation: a * value² + b * value + c.
The units for the analog values will not be shown if station has not sent a UNIT-packet specifying what unit's to use.
The parameter names for the digital bits will be Bit1, Bit2, Bit3 (up to Bit8) if station has not sent a PARAM-packet that specifies the parameter names for each digital bit.
All bit labels will be named "On" if station has not sent a UNIT-packet that specifies the label of each bit.
A bit is considered to be On when the bit is 1 if station has not sent a BITS-packet that specifies another "Bit sense" (a BITS-packet specify the state of the bits that match the BIT labels)