APRS Track Direct

My position About ☰

reset

OK1OBR-12 Telemetry

This is the latest recevied telemetry packets stored in our database for station/object OK1OBR-12. If no packets are shown the sender has not sent any telemetry packets the latest 1 day(s).

Telemetry packets is used to share measurements like repeteater parameters, battery voltage, radiation readings (or any other measurements).

<< 1 2 >>

Time	TX*	RX*	Digi*
1778023585	895 Count	396 Count	242 Count
1778021781	894 Count	396 Count	242 Count
1778019977	893 Count	396 Count	242 Count
1778018173	892 Count	396 Count	242 Count
1778016369	891 Count	396 Count	242 Count
1778014565	890 Count	396 Count	242 Count
1778012761	889 Count	396 Count	242 Count
1778010957	888 Count	396 Count	242 Count
1778009154	887 Count	396 Count	242 Count
1778007350	886 Count	396 Count	242 Count
1778005546	885 Count	395 Count	242 Count
1778003742	884 Count	395 Count	242 Count
1778001983	883 Count	395 Count	242 Count
1778000179	882 Count	395 Count	242 Count
1777998375	881 Count	395 Count	242 Count
1777996571	880 Count	395 Count	242 Count
1777994773	879 Count	395 Count	242 Count
1777992964	878 Count	395 Count	242 Count
1777991160	871 Count	389 Count	236 Count
1777989356	868 Count	387 Count	234 Count
1777987552	865 Count	385 Count	232 Count
1777985748	862 Count	383 Count	230 Count
1777983944	859 Count	381 Count	228 Count
1777982140	856 Count	379 Count	226 Count
1777980384	853 Count	377 Count	224 Count

*Used Equation Coefficients:

TX: 0, 1, 0

RX: 0, 1, 0

Digi: 0, 1, 0

V_Bat: 0, 0.01, 0

V_Ext: 0, 0.02, 0

The parameter names for the analog channels will be Value1, Value2, Value3 (up to Value5) if station has not sent a PARAM-packet that specifies the parameter names for each analog channel.
Each analog value is a decimal number between 000 and 255 (according to APRS specifications). The receiver use the telemetry equation coefficientsto to restore the original sensor values. If no EQNS-packet with equation coefficients is sent we will show the values as is (this corresponds to the equation coefficients a=0, b=1 and c=0).
The sent equation coefficients is used in the equation: a * value² + b * value + c.
The units for the analog values will not be shown if station has not sent a UNIT-packet specifying what unit's to use.
The parameter names for the digital bits will be Bit1, Bit2, Bit3 (up to Bit8) if station has not sent a PARAM-packet that specifies the parameter names for each digital bit.
All bit labels will be named "On" if station has not sent a UNIT-packet that specifies the label of each bit.
A bit is considered to be On when the bit is 1 if station has not sent a BITS-packet that specifies another "Bit sense" (a BITS-packet specify the state of the bits that match the BIT labels)