APRS Track Direct

My position About ☰

reset

F4MLV-2 Telemetry

This is the latest recevied telemetry packets stored in our database for station/object F4MLV-2. If no packets are shown the sender has not sent any telemetry packets the latest 1 day(s).

Telemetry packets is used to share measurements like repeteater parameters, battery voltage, radiation readings (or any other measurements).

<< 1 2 >>

Time	TX*	RX*	Digi*
1780142736	221 Count	318 Count	193 Count
1780140933	164 Count	234 Count	143 Count
1780139125	103 Count	156 Count	90 Count
1780137401	57 Count	85 Count	51 Count
1780135610	619 Count	1006 Count	493 Count
1780133794	564 Count	920 Count	445 Count
1780131990	504 Count	829 Count	394 Count
1780130186	454 Count	749 Count	355 Count
1780128382	418 Count	693 Count	329 Count
1780126579	376 Count	636 Count	296 Count
1780124775	331 Count	583 Count	262 Count
1780122971	292 Count	520 Count	231 Count
1780121167	259 Count	476 Count	207 Count
1780119364	218 Count	418 Count	173 Count
1780117560	175 Count	340 Count	141 Count
1780094524	174 Count	339 Count	141 Count
1780092715	131 Count	260 Count	106 Count
1780090911	90 Count	178 Count	73 Count
1780089108	40 Count	90 Count	33 Count
1780087304	676 Count	1031 Count	562 Count
1780085500	621 Count	931 Count	516 Count
1780083696	569 Count	852 Count	472 Count
1780081893	522 Count	786 Count	432 Count
1780080089	453 Count	692 Count	373 Count
1780080069	452 Count	692 Count	373 Count

*Used Equation Coefficients:

TX: 0, 1, 0

RX: 0, 1, 0

Digi: 0, 1, 0

V_Bat: 0, 0.01, 0

V_Ext: 0, 0.02, 0

The parameter names for the analog channels will be Value1, Value2, Value3 (up to Value5) if station has not sent a PARAM-packet that specifies the parameter names for each analog channel.
Each analog value is a decimal number between 000 and 255 (according to APRS specifications). The receiver use the telemetry equation coefficientsto to restore the original sensor values. If no EQNS-packet with equation coefficients is sent we will show the values as is (this corresponds to the equation coefficients a=0, b=1 and c=0).
The sent equation coefficients is used in the equation: a * value² + b * value + c.
The units for the analog values will not be shown if station has not sent a UNIT-packet specifying what unit's to use.
The parameter names for the digital bits will be Bit1, Bit2, Bit3 (up to Bit8) if station has not sent a PARAM-packet that specifies the parameter names for each digital bit.
All bit labels will be named "On" if station has not sent a UNIT-packet that specifies the label of each bit.
A bit is considered to be On when the bit is 1 if station has not sent a BITS-packet that specifies another "Bit sense" (a BITS-packet specify the state of the bits that match the BIT labels)