APRS Track Direct

My position About ☰

reset

LU2HT-1 Telemetry

This is the latest recevied telemetry packets stored in our database for station/object LU2HT-1. If no packets are shown the sender has not sent any telemetry packets the latest 1 day(s).

Telemetry packets is used to share measurements like repeteater parameters, battery voltage, radiation readings (or any other measurements).

<< 1 2 3 4 >>

Time	RSSI*	Voltage*
1754685310	31 dBm	14.19 V
1754684688	31 dBm	14.19 V
1754684066	31 dBm	14.19 V
1754683443	31 dBm	14.19 V
1754682200	31 dBm	14.19 V
1754681577	31 dBm	14.19 V
1754680954	31 dBm	14.19 V
1754678468	31 dBm	14.19 V
1754677846	31 dBm	14.19 V
1754677224	31 dBm	14.19 V
1754675980	31 dBm	14.21 V
1754675359	31 dBm	14.17 V
1754674745	31 dBm	14.23 V
1754674115	31 dBm	14.19 V
1754672249	31 dBm	14.23 V
1754669101	31 dBm	14.17 V
1754666624	31 dBm	14.19 V
1754665990	31 dBm	14.19 V
1754665371	31 dBm	14.17 V
1754664127	31 dBm	14.17 V
1754663505	31 dBm	14.23 V
1754662257	31 dBm	14.17 V
1754661635	31 dBm	14.19 V
1754661013	31 dBm	14.19 V
1754660391	31 dBm	14.17 V

*Used Equation Coefficients:

RxTraffic: 0, 1, 0

TxTraffic: 0, 1, 0

RxDrop: 0, 1, 0

RSSI: 0, -1, 0

Voltage: 0, 1, 0

The parameter names for the analog channels will be Value1, Value2, Value3 (up to Value5) if station has not sent a PARAM-packet that specifies the parameter names for each analog channel.
Each analog value is a decimal number between 000 and 255 (according to APRS specifications). The receiver use the telemetry equation coefficientsto to restore the original sensor values. If no EQNS-packet with equation coefficients is sent we will show the values as is (this corresponds to the equation coefficients a=0, b=1 and c=0).
The sent equation coefficients is used in the equation: a * value² + b * value + c.
The units for the analog values will not be shown if station has not sent a UNIT-packet specifying what unit's to use.
The parameter names for the digital bits will be Bit1, Bit2, Bit3 (up to Bit8) if station has not sent a PARAM-packet that specifies the parameter names for each digital bit.
All bit labels will be named "On" if station has not sent a UNIT-packet that specifies the label of each bit.
A bit is considered to be On when the bit is 1 if station has not sent a BITS-packet that specifies another "Bit sense" (a BITS-packet specify the state of the bits that match the BIT labels)