APRS Track Direct

My position About ☰

reset

LB3AG-11 Telemetry

This is the latest recevied telemetry packets stored in our database for station/object LB3AG-11. If no packets are shown the sender has not sent any telemetry packets the latest 1 day(s).

Telemetry packets is used to share measurements like repeteater parameters, battery voltage, radiation readings (or any other measurements).

<< 1 2 3 4 >>

Time	TX*	RX*	Digi*
1786740195	317 Count	567 Count	202 Count
1786739592	313 Count	558 Count	199 Count
1786738989	311 Count	554 Count	198 Count
1786738386	308 Count	549 Count	196 Count
1786737898	304 Count	546 Count	193 Count
1786737295	302 Count	539 Count	192 Count
1786736692	299 Count	533 Count	190 Count
1786736088	295 Count	527 Count	187 Count
1786735488	293 Count	523 Count	186 Count
1786734882	291 Count	518 Count	185 Count
1786733676	285 Count	510 Count	181 Count
1786733072	282 Count	505 Count	179 Count
1786732469	278 Count	499 Count	176 Count
1786731867	276 Count	497 Count	175 Count
1786731265	273 Count	494 Count	173 Count
1786730660	269 Count	490 Count	170 Count
1786729454	264 Count	481 Count	167 Count
1786728851	260 Count	475 Count	164 Count
1786728247	258 Count	471 Count	163 Count
1786727645	255 Count	465 Count	161 Count
1786727041	251 Count	459 Count	158 Count
1786726438	249 Count	454 Count	157 Count
1786725835	246 Count	449 Count	155 Count
1786725232	243 Count	442 Count	153 Count
1786724629	241 Count	438 Count	152 Count

*Used Equation Coefficients:

TX: 0, 1, 0

RX: 0, 1, 0

Digi: 0, 1, 0

V_Bat: 0, 0.01, 0

V_Ext: 0, 0.02, 0

The parameter names for the analog channels will be Value1, Value2, Value3 (up to Value5) if station has not sent a PARAM-packet that specifies the parameter names for each analog channel.
Each analog value is a decimal number between 000 and 255 (according to APRS specifications). The receiver use the telemetry equation coefficientsto to restore the original sensor values. If no EQNS-packet with equation coefficients is sent we will show the values as is (this corresponds to the equation coefficients a=0, b=1 and c=0).
The sent equation coefficients is used in the equation: a * value² + b * value + c.
The units for the analog values will not be shown if station has not sent a UNIT-packet specifying what unit's to use.
The parameter names for the digital bits will be Bit1, Bit2, Bit3 (up to Bit8) if station has not sent a PARAM-packet that specifies the parameter names for each digital bit.
All bit labels will be named "On" if station has not sent a UNIT-packet that specifies the label of each bit.
A bit is considered to be On when the bit is 1 if station has not sent a BITS-packet that specifies another "Bit sense" (a BITS-packet specify the state of the bits that match the BIT labels)