APRS Track Direct

My position About ☰

reset

SP8AA-1 Telemetry

This is the latest recevied telemetry packets stored in our database for station/object SP8AA-1. If no packets are shown the sender has not sent any telemetry packets the latest 1 day(s).

Telemetry packets is used to share measurements like repeteater parameters, battery voltage, radiation readings (or any other measurements).

<< 1 2 >>

Time	TX*	RX*	Digi*
1786726433	211 Count	247 Count	198 Count
1786725526	198 Count	231 Count	186 Count
1786724625	188 Count	219 Count	177 Count
1786723722	169 Count	196 Count	159 Count
1786721911	124 Count	144 Count	116 Count
1786721005	111 Count	129 Count	104 Count
1786720104	95 Count	111 Count	89 Count
1786719199	82 Count	97 Count	77 Count
1786718291	67 Count	79 Count	63 Count
1786717386	48 Count	58 Count	45 Count
1786716480	35 Count	43 Count	33 Count
1786715579	25 Count	31 Count	24 Count
1786713760	615 Count	1007 Count	550 Count
1786712853	602 Count	994 Count	538 Count
1786712061	587 Count	981 Count	528 Count
1786711153	574 Count	963 Count	516 Count
1786710249	562 Count	949 Count	505 Count
1786709345	547 Count	930 Count	491 Count
1786708439	535 Count	916 Count	480 Count
1786707535	524 Count	901 Count	470 Count
1786706634	510 Count	885 Count	457 Count
1786705731	499 Count	870 Count	447 Count
1786704823	485 Count	855 Count	434 Count
1786703917	472 Count	840 Count	422 Count
1786703011	460 Count	826 Count	411 Count

*Used Equation Coefficients:

TX: 0, 1, 0

RX: 0, 1, 0

Digi: 0, 1, 0

V_Bat: 0, 0.01, 0

V_Ext: 0, 0.02, 0

The parameter names for the analog channels will be Value1, Value2, Value3 (up to Value5) if station has not sent a PARAM-packet that specifies the parameter names for each analog channel.
Each analog value is a decimal number between 000 and 255 (according to APRS specifications). The receiver use the telemetry equation coefficientsto to restore the original sensor values. If no EQNS-packet with equation coefficients is sent we will show the values as is (this corresponds to the equation coefficients a=0, b=1 and c=0).
The sent equation coefficients is used in the equation: a * value² + b * value + c.
The units for the analog values will not be shown if station has not sent a UNIT-packet specifying what unit's to use.
The parameter names for the digital bits will be Bit1, Bit2, Bit3 (up to Bit8) if station has not sent a PARAM-packet that specifies the parameter names for each digital bit.
All bit labels will be named "On" if station has not sent a UNIT-packet that specifies the label of each bit.
A bit is considered to be On when the bit is 1 if station has not sent a BITS-packet that specifies another "Bit sense" (a BITS-packet specify the state of the bits that match the BIT labels)