APRS Track Direct

My position About ☰

reset

UN1GWA-1 Telemetry

This is the latest recevied telemetry packets stored in our database for station/object UN1GWA-1. If no packets are shown the sender has not sent any telemetry packets the latest 1 day(s).

Telemetry packets is used to share measurements like repeteater parameters, battery voltage, radiation readings (or any other measurements).

<< 1 2 3 4 >>

Time	TX*	RX*	Digi*
1779924050	79 Count	231 Count	50 Count
1779923144	77 Count	225 Count	49 Count
1779922239	74 Count	217 Count	47 Count
1779921333	71 Count	210 Count	45 Count
1779920427	68 Count	200 Count	43 Count
1779919522	66 Count	192 Count	42 Count
1779918616	63 Count	184 Count	40 Count
1779917711	61 Count	178 Count	39 Count
1779916805	58 Count	169 Count	37 Count
1779916034	56 Count	160 Count	36 Count
1779915129	54 Count	151 Count	35 Count
1779914223	51 Count	143 Count	33 Count
1779913318	48 Count	134 Count	31 Count
1779912412	45 Count	126 Count	29 Count
1779911507	42 Count	118 Count	27 Count
1779910601	39 Count	111 Count	25 Count
1779909696	36 Count	103 Count	23 Count
1779908790	33 Count	96 Count	21 Count
1779907885	31 Count	88 Count	20 Count
1779906979	28 Count	81 Count	18 Count
1779906074	25 Count	70 Count	16 Count
1779905169	22 Count	60 Count	14 Count
1779904263	19 Count	54 Count	12 Count
1779903358	17 Count	50 Count	11 Count
1779902452	15 Count	42 Count	10 Count

*Used Equation Coefficients:

TX: 0, 1, 0

RX: 0, 1, 0

Digi: 0, 1, 0

V_Bat: 0, 0.01, 0

V_Ext: 0, 0.02, 0

The parameter names for the analog channels will be Value1, Value2, Value3 (up to Value5) if station has not sent a PARAM-packet that specifies the parameter names for each analog channel.
Each analog value is a decimal number between 000 and 255 (according to APRS specifications). The receiver use the telemetry equation coefficientsto to restore the original sensor values. If no EQNS-packet with equation coefficients is sent we will show the values as is (this corresponds to the equation coefficients a=0, b=1 and c=0).
The sent equation coefficients is used in the equation: a * value² + b * value + c.
The units for the analog values will not be shown if station has not sent a UNIT-packet specifying what unit's to use.
The parameter names for the digital bits will be Bit1, Bit2, Bit3 (up to Bit8) if station has not sent a PARAM-packet that specifies the parameter names for each digital bit.
All bit labels will be named "On" if station has not sent a UNIT-packet that specifies the label of each bit.
A bit is considered to be On when the bit is 1 if station has not sent a BITS-packet that specifies another "Bit sense" (a BITS-packet specify the state of the bits that match the BIT labels)