APRS Track Direct

My position About ☰

reset

IU0REK-15 Telemetry

This is the latest recevied telemetry packets stored in our database for station/object IU0REK-15. If no packets are shown the sender has not sent any telemetry packets the latest 1 day(s).

Telemetry packets is used to share measurements like repeteater parameters, battery voltage, radiation readings (or any other measurements).

<< 1 2 3 >>

Time	Vin*	Temp*
1790674958	14.18 Volt	24 C
1790673457	13.8 Volt	22.5 C
1790671955	13.73 Volt	21.5 C
1790670454	13.73 Volt	20.5 C
1790668952	13.65 Volt	19.5 C
1790667451	13.65 Volt	18.5 C
1790665950	13.58 Volt	17.5 C
1790664448	13.5 Volt	16.5 C
1790662947	13.43 Volt	16 C
1790661445	13.43 Volt	15.5 C
1790659944	13.35 Volt	15.5 C
1790658442	13.35 Volt	15 C
1790656941	13.43 Volt	15 C
1790655439	13.35 Volt	15 C
1790653938	13.35 Volt	15.5 C
1790652437	13.43 Volt	16 C
1790650935	13.35 Volt	16.5 C
1790649434	13.43 Volt	16.5 C
1790647934	13.43 Volt	17 C
1790646431	13.43 Volt	17 C
1790644930	13.43 Volt	17 C
1790643429	13.43 Volt	17 C
1790641926	13.43 Volt	17.5 C
1790638924	13.43 Volt	18 C
1790637423	13.43 Volt	18.5 C

*Used Equation Coefficients:

Vin: 0, 0.075, 0

Rx1h: 0, 10, 0

Dg1h: 0, 10, 0

Eff1h: 0, 1, 0

Temp: 0, 0.5, -64

The parameter names for the analog channels will be Value1, Value2, Value3 (up to Value5) if station has not sent a PARAM-packet that specifies the parameter names for each analog channel.
Each analog value is a decimal number between 000 and 255 (according to APRS specifications). The receiver use the telemetry equation coefficientsto to restore the original sensor values. If no EQNS-packet with equation coefficients is sent we will show the values as is (this corresponds to the equation coefficients a=0, b=1 and c=0).
The sent equation coefficients is used in the equation: a * value² + b * value + c.
The units for the analog values will not be shown if station has not sent a UNIT-packet specifying what unit's to use.
The parameter names for the digital bits will be Bit1, Bit2, Bit3 (up to Bit8) if station has not sent a PARAM-packet that specifies the parameter names for each digital bit.
All bit labels will be named "On" if station has not sent a UNIT-packet that specifies the label of each bit.
A bit is considered to be On when the bit is 1 if station has not sent a BITS-packet that specifies another "Bit sense" (a BITS-packet specify the state of the bits that match the BIT labels)