APRS Track Direct

My position About ☰

reset

SP7TBU-1 Telemetry

This is the latest recevied telemetry packets stored in our database for station/object SP7TBU-1. If no packets are shown the sender has not sent any telemetry packets the latest 1 day(s).

Telemetry packets is used to share measurements like repeteater parameters, battery voltage, radiation readings (or any other measurements).

<< 1 2 3 >>

Time	TX*	RX*	Digi*
1782488149	194 Count	658 Count	120 Count
1782486948	184 Count	601 Count	114 Count
1782485747	170 Count	558 Count	107 Count
1782484546	154 Count	518 Count	100 Count
1782483346	138 Count	479 Count	93 Count
1782482147	120 Count	438 Count	85 Count
1782480946	109 Count	409 Count	78 Count
1782478542	91 Count	331 Count	65 Count
1782477340	82 Count	285 Count	58 Count
1782476139	74 Count	248 Count	52 Count
1782474953	60 Count	221 Count	46 Count
1782473754	51 Count	179 Count	39 Count
1782472551	44 Count	135 Count	34 Count
1782471350	32 Count	97 Count	25 Count
1782470149	21 Count	61 Count	17 Count
1782468949	13 Count	30 Count	11 Count
1782467748	259 Count	1022 Count	207 Count
1782466547	247 Count	994 Count	201 Count
1782465346	240 Count	969 Count	195 Count
1782464145	230 Count	948 Count	188 Count
1782462944	219 Count	919 Count	180 Count
1782461743	212 Count	888 Count	175 Count
1782460543	202 Count	857 Count	168 Count
1782459344	192 Count	817 Count	160 Count
1782458140	178 Count	770 Count	149 Count

*Used Equation Coefficients:

TX: 0, 1, 0

RX: 0, 1, 0

Digi: 0, 1, 0

V_Bat: 0, 0.01, 0

V_Ext: 0, 0.02, 0

The parameter names for the analog channels will be Value1, Value2, Value3 (up to Value5) if station has not sent a PARAM-packet that specifies the parameter names for each analog channel.
Each analog value is a decimal number between 000 and 255 (according to APRS specifications). The receiver use the telemetry equation coefficientsto to restore the original sensor values. If no EQNS-packet with equation coefficients is sent we will show the values as is (this corresponds to the equation coefficients a=0, b=1 and c=0).
The sent equation coefficients is used in the equation: a * value² + b * value + c.
The units for the analog values will not be shown if station has not sent a UNIT-packet specifying what unit's to use.
The parameter names for the digital bits will be Bit1, Bit2, Bit3 (up to Bit8) if station has not sent a PARAM-packet that specifies the parameter names for each digital bit.
All bit labels will be named "On" if station has not sent a UNIT-packet that specifies the label of each bit.
A bit is considered to be On when the bit is 1 if station has not sent a BITS-packet that specifies another "Bit sense" (a BITS-packet specify the state of the bits that match the BIT labels)