APRS Track Direct

My position About ☰

reset

PE1PMD-10 Telemetry

This is the latest recevied telemetry packets stored in our database for station/object PE1PMD-10. If no packets are shown the sender has not sent any telemetry packets the latest 1 day(s).

Telemetry packets is used to share measurements like repeteater parameters, battery voltage, radiation readings (or any other measurements).

<< 1 2 3 4 >>

Time	TX*	RX*	Digi*
1790682758	649 Count	461 Count	455 Count
1790681854	648 Count	461 Count	455 Count
1790680951	643 Count	457 Count	451 Count
1790680047	642 Count	457 Count	451 Count
1790679144	640 Count	456 Count	450 Count
1790678240	638 Count	455 Count	449 Count
1790677336	637 Count	455 Count	449 Count
1790676433	636 Count	455 Count	449 Count
1790675529	628 Count	448 Count	442 Count
1790674626	604 Count	425 Count	419 Count
1790673722	601 Count	423 Count	417 Count
1790672819	600 Count	423 Count	417 Count
1790671919	598 Count	422 Count	416 Count
1790671011	596 Count	421 Count	415 Count
1790670107	594 Count	420 Count	414 Count
1790669204	592 Count	419 Count	413 Count
1790668300	590 Count	418 Count	412 Count
1790667397	588 Count	417 Count	411 Count
1790666580	586 Count	416 Count	410 Count
1790665676	584 Count	415 Count	409 Count
1790664772	582 Count	414 Count	408 Count
1790663869	580 Count	413 Count	407 Count
1790662966	578 Count	412 Count	406 Count
1790662062	576 Count	411 Count	405 Count
1790661158	574 Count	410 Count	404 Count

*Used Equation Coefficients:

TX: 0, 1, 0

RX: 0, 1, 0

Digi: 0, 1, 0

V_Bat: 0, 0.01, 0

V_Ext: 0, 0.02, 0

The parameter names for the analog channels will be Value1, Value2, Value3 (up to Value5) if station has not sent a PARAM-packet that specifies the parameter names for each analog channel.
Each analog value is a decimal number between 000 and 255 (according to APRS specifications). The receiver use the telemetry equation coefficientsto to restore the original sensor values. If no EQNS-packet with equation coefficients is sent we will show the values as is (this corresponds to the equation coefficients a=0, b=1 and c=0).
The sent equation coefficients is used in the equation: a * value² + b * value + c.
The units for the analog values will not be shown if station has not sent a UNIT-packet specifying what unit's to use.
The parameter names for the digital bits will be Bit1, Bit2, Bit3 (up to Bit8) if station has not sent a PARAM-packet that specifies the parameter names for each digital bit.
All bit labels will be named "On" if station has not sent a UNIT-packet that specifies the label of each bit.
A bit is considered to be On when the bit is 1 if station has not sent a BITS-packet that specifies another "Bit sense" (a BITS-packet specify the state of the bits that match the BIT labels)