APRS Track Direct

My position About ☰

reset

9W8ASH-1 Telemetry

This is the latest recevied telemetry packets stored in our database for station/object 9W8ASH-1. If no packets are shown the sender has not sent any telemetry packets the latest 1 day(s).

Telemetry packets is used to share measurements like repeteater parameters, battery voltage, radiation readings (or any other measurements).

Time	TX*	RX*	Digi*
1779742470	153 Count	167 Count	51 Count
1779735267	866 Count	1151 Count	379 Count
1779728063	712 Count	972 Count	319 Count
1779720866	553 Count	780 Count	266 Count
1779713662	386 Count	588 Count	210 Count
1779706459	179 Count	332 Count	118 Count
1779699264	429 Count	1088 Count	424 Count
1779692064	343 Count	867 Count	340 Count
1779684860	256 Count	676 Count	254 Count
1779677663	111 Count	333 Count	111 Count
1779670459	784 Count	1013 Count	324 Count
1779663277	557 Count	696 Count	190 Count
1779663256	559 Count	697 Count	191 Count
1779663227	557 Count	696 Count	190 Count

*Used Equation Coefficients:

TX: 0, 1, 0

RX: 0, 1, 0

Digi: 0, 1, 0

V_Bat: 0, 0.01, 0

V_Ext: 0, 0.02, 0

The parameter names for the analog channels will be Value1, Value2, Value3 (up to Value5) if station has not sent a PARAM-packet that specifies the parameter names for each analog channel.
Each analog value is a decimal number between 000 and 255 (according to APRS specifications). The receiver use the telemetry equation coefficientsto to restore the original sensor values. If no EQNS-packet with equation coefficients is sent we will show the values as is (this corresponds to the equation coefficients a=0, b=1 and c=0).
The sent equation coefficients is used in the equation: a * value² + b * value + c.
The units for the analog values will not be shown if station has not sent a UNIT-packet specifying what unit's to use.
The parameter names for the digital bits will be Bit1, Bit2, Bit3 (up to Bit8) if station has not sent a PARAM-packet that specifies the parameter names for each digital bit.
All bit labels will be named "On" if station has not sent a UNIT-packet that specifies the label of each bit.
A bit is considered to be On when the bit is 1 if station has not sent a BITS-packet that specifies another "Bit sense" (a BITS-packet specify the state of the bits that match the BIT labels)