APRS Track Direct

My position About ☰

reset

PE1PNX-10 Telemetry

This is the latest recevied telemetry packets stored in our database for station/object PE1PNX-10. If no packets are shown the sender has not sent any telemetry packets the latest 1 day(s).

Telemetry packets is used to share measurements like repeteater parameters, battery voltage, radiation readings (or any other measurements).

<< 1 2 >>

Time	TX*	RX*	Digi*
1786715203	330 Count	216 Count	56 Count
1786714247	325 Count	216 Count	56 Count
1786714226	321 Count	216 Count	56 Count
1786712422	320 Count	216 Count	56 Count
1786710618	319 Count	216 Count	56 Count
1786708815	318 Count	216 Count	56 Count
1786707011	317 Count	216 Count	56 Count
1786705207	316 Count	216 Count	56 Count
1786704886	311 Count	216 Count	56 Count
1786703083	310 Count	216 Count	56 Count
1786701279	309 Count	216 Count	56 Count
1786701258	305 Count	216 Count	56 Count
1786699454	304 Count	216 Count	56 Count
1786697651	303 Count	216 Count	56 Count
1786695847	302 Count	216 Count	56 Count
1786694043	301 Count	216 Count	56 Count
1786692240	300 Count	216 Count	56 Count
1786692215	296 Count	216 Count	56 Count
1786690411	295 Count	216 Count	56 Count
1786688608	294 Count	215 Count	56 Count
1786686804	293 Count	213 Count	56 Count
1786685000	292 Count	210 Count	56 Count
1786683197	291 Count	204 Count	56 Count
1786681393	286 Count	164 Count	52 Count
1786679589	285 Count	156 Count	52 Count

*Used Equation Coefficients:

TX: 0, 1, 0

RX: 0, 1, 0

Digi: 0, 1, 0

V_Bat: 0, 0.01, 0

V_Ext: 0, 0.02, 0

The parameter names for the analog channels will be Value1, Value2, Value3 (up to Value5) if station has not sent a PARAM-packet that specifies the parameter names for each analog channel.
Each analog value is a decimal number between 000 and 255 (according to APRS specifications). The receiver use the telemetry equation coefficientsto to restore the original sensor values. If no EQNS-packet with equation coefficients is sent we will show the values as is (this corresponds to the equation coefficients a=0, b=1 and c=0).
The sent equation coefficients is used in the equation: a * value² + b * value + c.
The units for the analog values will not be shown if station has not sent a UNIT-packet specifying what unit's to use.
The parameter names for the digital bits will be Bit1, Bit2, Bit3 (up to Bit8) if station has not sent a PARAM-packet that specifies the parameter names for each digital bit.
All bit labels will be named "On" if station has not sent a UNIT-packet that specifies the label of each bit.
A bit is considered to be On when the bit is 1 if station has not sent a BITS-packet that specifies another "Bit sense" (a BITS-packet specify the state of the bits that match the BIT labels)