APRS Track Direct

My position About ☰

reset

SQ5RTW-4 Telemetry

This is the latest recevied telemetry packets stored in our database for station/object SQ5RTW-4. If no packets are shown the sender has not sent any telemetry packets the latest 1 day(s).

Telemetry packets is used to share measurements like repeteater parameters, battery voltage, radiation readings (or any other measurements).

Time	TX*	RX*	Digi*
1777975964	100 Count	460 Count	68 Count
1777975043	99 Count	460 Count	68 Count
1777973241	96 Count	451 Count	66 Count
1777971440	93 Count	442 Count	64 Count
1777969639	90 Count	430 Count	62 Count
1777967838	87 Count	416 Count	60 Count
1777966037	84 Count	404 Count	58 Count
1777964236	81 Count	393 Count	56 Count
1777962435	78 Count	381 Count	54 Count
1777960634	75 Count	366 Count	52 Count
1777958833	71 Count	351 Count	49 Count
1777957033	67 Count	329 Count	46 Count
1777955232	63 Count	313 Count	43 Count
1777953438	60 Count	298 Count	41 Count
1777951637	58 Count	264 Count	40 Count
1777949836	54 Count	253 Count	38 Count
1777948035	50 Count	235 Count	35 Count
1777946234	44 Count	201 Count	30 Count
1777944433	38 Count	168 Count	25 Count
1777942632	32 Count	130 Count	20 Count
1777940831	26 Count	96 Count	15 Count
1777939030	20 Count	62 Count	10 Count
1777937230	15 Count	41 Count	6 Count

*Used Equation Coefficients:

TX: 0, 1, 0

RX: 0, 1, 0

Digi: 0, 1, 0

V_Bat: 0, 0.01, 0

V_Ext: 0, 0.02, 0

The parameter names for the analog channels will be Value1, Value2, Value3 (up to Value5) if station has not sent a PARAM-packet that specifies the parameter names for each analog channel.
Each analog value is a decimal number between 000 and 255 (according to APRS specifications). The receiver use the telemetry equation coefficientsto to restore the original sensor values. If no EQNS-packet with equation coefficients is sent we will show the values as is (this corresponds to the equation coefficients a=0, b=1 and c=0).
The sent equation coefficients is used in the equation: a * value² + b * value + c.
The units for the analog values will not be shown if station has not sent a UNIT-packet specifying what unit's to use.
The parameter names for the digital bits will be Bit1, Bit2, Bit3 (up to Bit8) if station has not sent a PARAM-packet that specifies the parameter names for each digital bit.
All bit labels will be named "On" if station has not sent a UNIT-packet that specifies the label of each bit.
A bit is considered to be On when the bit is 1 if station has not sent a BITS-packet that specifies another "Bit sense" (a BITS-packet specify the state of the bits that match the BIT labels)