APRS Track Direct

My position About ☰

reset

9W2PEF-2 Telemetry

This is the latest recevied telemetry packets stored in our database for station/object 9W2PEF-2. If no packets are shown the sender has not sent any telemetry packets the latest 1 day(s).

Telemetry packets is used to share measurements like repeteater parameters, battery voltage, radiation readings (or any other measurements).

<< 1 2 3 4 >>

Time	RSSI*	Voltage*
1778041614	-69 dBm	12.33 V
1778040988	-73 dBm	12.33 V
1778040363	-66 dBm	12.33 V
1778039737	-72 dBm	12.33 V
1778039112	-68 dBm	12.33 V
1778038487	-65 dBm	12.33 V
1778037861	-64 dBm	12.35 V
1778037235	-66 dBm	12.33 V
1778036610	-67 dBm	12.3 V
1778036189	-60 dBm	12.3 V
1778035564	-66 dBm	12.33 V
1778034937	-60 dBm	12.33 V
1778034312	-61 dBm	12.33 V
1778033687	-63 dBm	12.33 V
1778033062	-64 dBm	12.33 V
1778032437	-67 dBm	12.33 V
1778031811	-67 dBm	12.33 V
1778031186	-62 dBm	12.33 V
1778030561	-63 dBm	12.33 V
1778029936	-69 dBm	12.33 V
1778029311	-66 dBm	12.33 V
1778028684	-64 dBm	12.33 V
1778028060	-65 dBm	12.33 V
1778027435	-65 dBm	12.33 V
1778026810	-65 dBm	12.33 V

*Used Equation Coefficients:

RxTraffic: 0, 1, 0

TxTraffic: 0, 1, 0

RxDrop: 0, 1, 0

RSSI: 0, -1, 0

Voltage: 0, 1, 0

The parameter names for the analog channels will be Value1, Value2, Value3 (up to Value5) if station has not sent a PARAM-packet that specifies the parameter names for each analog channel.
Each analog value is a decimal number between 000 and 255 (according to APRS specifications). The receiver use the telemetry equation coefficientsto to restore the original sensor values. If no EQNS-packet with equation coefficients is sent we will show the values as is (this corresponds to the equation coefficients a=0, b=1 and c=0).
The sent equation coefficients is used in the equation: a * value² + b * value + c.
The units for the analog values will not be shown if station has not sent a UNIT-packet specifying what unit's to use.
The parameter names for the digital bits will be Bit1, Bit2, Bit3 (up to Bit8) if station has not sent a PARAM-packet that specifies the parameter names for each digital bit.
All bit labels will be named "On" if station has not sent a UNIT-packet that specifies the label of each bit.
A bit is considered to be On when the bit is 1 if station has not sent a BITS-packet that specifies another "Bit sense" (a BITS-packet specify the state of the bits that match the BIT labels)