APRS Track Direct

My position About ☰

reset

SQ9KFP-2 Telemetry

This is the latest recevied telemetry packets stored in our database for station/object SQ9KFP-2. If no packets are shown the sender has not sent any telemetry packets the latest 1 day(s).

Telemetry packets is used to share measurements like repeteater parameters, battery voltage, radiation readings (or any other measurements).

<< 1 2 3 4 >>

Time	TX*	RX*
1779828909	287 Count	973 Count
1779828045	282 Count	973 Count
1779827631	272 Count	973 Count
1779826730	271 Count	964 Count
1779825830	270 Count	956 Count
1779824929	269 Count	946 Count
1779823164	263 Count	938 Count
1779822264	262 Count	913 Count
1779821363	261 Count	903 Count
1779819694	255 Count	896 Count
1779818794	254 Count	887 Count
1779817898	253 Count	881 Count
1779817831	248 Count	881 Count
1779816930	247 Count	877 Count
1779816030	246 Count	872 Count
1779812427	242 Count	849 Count
1779811527	241 Count	845 Count
1779809731	239 Count	838 Count
1779807016	232 Count	831 Count
1779804936	225 Count	830 Count
1779804384	220 Count	830 Count
1779803647	215 Count	830 Count
1779802747	214 Count	828 Count
1779798245	209 Count	814 Count
1779797656	204 Count	814 Count

*Used Equation Coefficients:

TX: 0, 1, 0

RX: 0, 1, 0

Digi: 0, 1, 0

V_Bat: 0, 0.01, 0

V_Ext: 0, 0.02, 0

The parameter names for the analog channels will be Value1, Value2, Value3 (up to Value5) if station has not sent a PARAM-packet that specifies the parameter names for each analog channel.
Each analog value is a decimal number between 000 and 255 (according to APRS specifications). The receiver use the telemetry equation coefficientsto to restore the original sensor values. If no EQNS-packet with equation coefficients is sent we will show the values as is (this corresponds to the equation coefficients a=0, b=1 and c=0).
The sent equation coefficients is used in the equation: a * value² + b * value + c.
The units for the analog values will not be shown if station has not sent a UNIT-packet specifying what unit's to use.
The parameter names for the digital bits will be Bit1, Bit2, Bit3 (up to Bit8) if station has not sent a PARAM-packet that specifies the parameter names for each digital bit.
All bit labels will be named "On" if station has not sent a UNIT-packet that specifies the label of each bit.
A bit is considered to be On when the bit is 1 if station has not sent a BITS-packet that specifies another "Bit sense" (a BITS-packet specify the state of the bits that match the BIT labels)