APRS Track Direct

My position About ☰

reset

M9NSZ-11 Telemetry

This is the latest recevied telemetry packets stored in our database for station/object M9NSZ-11. If no packets are shown the sender has not sent any telemetry packets the latest 1 day(s).

Telemetry packets is used to share measurements like repeteater parameters, battery voltage, radiation readings (or any other measurements).

<< 1 2 >>

Time	TX*	RX*
1790646663	4 Count	31 Count
1790644860	3 Count	27 Count
1790643094	2 Count	20 Count
1790641291	1 Count	11 Count
1790639488	0 Count	8 Count
1790637685	68 Count	1011 Count
1790635882	67 Count	997 Count
1790632275	65 Count	979 Count
1790630472	64 Count	975 Count
1790628669	63 Count	963 Count
1790626866	62 Count	951 Count
1790625063	61 Count	944 Count
1790623260	60 Count	935 Count
1790621494	59 Count	916 Count
1790619691	58 Count	902 Count
1790617888	57 Count	885 Count
1790616085	56 Count	863 Count
1790614282	55 Count	847 Count
1790612479	54 Count	829 Count
1790610675	53 Count	812 Count
1790608872	52 Count	775 Count
1790607069	51 Count	752 Count
1790605266	50 Count	737 Count
1790603463	49 Count	715 Count
1790599891	47 Count	675 Count

*Used Equation Coefficients:

TX: 0, 1, 0

RX: 0, 1, 0

Digi: 0, 1, 0

V_Bat: 0, 0.01, 0

V_Ext: 0, 0.02, 0

The parameter names for the analog channels will be Value1, Value2, Value3 (up to Value5) if station has not sent a PARAM-packet that specifies the parameter names for each analog channel.
Each analog value is a decimal number between 000 and 255 (according to APRS specifications). The receiver use the telemetry equation coefficientsto to restore the original sensor values. If no EQNS-packet with equation coefficients is sent we will show the values as is (this corresponds to the equation coefficients a=0, b=1 and c=0).
The sent equation coefficients is used in the equation: a * value² + b * value + c.
The units for the analog values will not be shown if station has not sent a UNIT-packet specifying what unit's to use.
The parameter names for the digital bits will be Bit1, Bit2, Bit3 (up to Bit8) if station has not sent a PARAM-packet that specifies the parameter names for each digital bit.
All bit labels will be named "On" if station has not sent a UNIT-packet that specifies the label of each bit.
A bit is considered to be On when the bit is 1 if station has not sent a BITS-packet that specifies another "Bit sense" (a BITS-packet specify the state of the bits that match the BIT labels)