APRS Track Direct

My position About ☰

reset

KH6DH-13 Telemetry

This is the latest recevied telemetry packets stored in our database for station/object KH6DH-13. If no packets are shown the sender has not sent any telemetry packets the latest 1 day(s).

Telemetry packets is used to share measurements like repeteater parameters, battery voltage, radiation readings (or any other measurements).

<< 1 2 >>

Time	Value1*	Value2*	Value3*	Value4*	Value5*
1774438453	133	104	255	93	73
1774435752	133	104	255	93	73
1774433051	133	104	255	93	73
1774430350	133	105	255	93	73
1774427649	133	105	255	92	73
1774424948	133	105	255	92	73
1774422247	133	106	255	92	72
1774419545	133	106	255	92	71
1774416844	133	107	255	92	71
1774414143	133	107	255	92	71
1774411442	133	109	255	91	70
1774408741	133	111	255	90	69
1774406040	133	111	255	89	68
1774403339	133	112	255	89	69
1774400638	133	112	255	89	68
1774397937	133	112	255	88	68
1774395236	133	111	255	89	69
1774392535	133	111	255	89	69
1774389834	133	110	255	90	69
1774387133	133	109	255	91	70
1774384432	133	108	255	91	71
1774381731	133	106	255	92	72
1774379030	133	104	255	93	73
1774376329	133	103	255	94	74
1774373628	133	102	255	94	74

*Used Equation Coefficients:

Value1: 0, 1, 0

Value2: 0, 1, 0

Value3: 0, 1, 0

Value4: 0, 1, 0

Value5: 0, 1, 0

The parameter names for the analog channels will be Value1, Value2, Value3 (up to Value5) if station has not sent a PARAM-packet that specifies the parameter names for each analog channel.
Each analog value is a decimal number between 000 and 255 (according to APRS specifications). The receiver use the telemetry equation coefficientsto to restore the original sensor values. If no EQNS-packet with equation coefficients is sent we will show the values as is (this corresponds to the equation coefficients a=0, b=1 and c=0).
The sent equation coefficients is used in the equation: a * value² + b * value + c.
The units for the analog values will not be shown if station has not sent a UNIT-packet specifying what unit's to use.
The parameter names for the digital bits will be Bit1, Bit2, Bit3 (up to Bit8) if station has not sent a PARAM-packet that specifies the parameter names for each digital bit.
All bit labels will be named "On" if station has not sent a UNIT-packet that specifies the label of each bit.
A bit is considered to be On when the bit is 1 if station has not sent a BITS-packet that specifies another "Bit sense" (a BITS-packet specify the state of the bits that match the BIT labels)