APRS Track Direct

My position About ☰

reset

MKGBRD Telemetry

This is the latest recevied telemetry packets stored in our database for station/object MKGBRD. If no packets are shown the sender has not sent any telemetry packets the latest 1 day(s).

Telemetry packets is used to share measurements like repeteater parameters, battery voltage, radiation readings (or any other measurements).

<< 1 2 >>

Time	Value1*	Value2*	Value3*	Value4*	Value5*
1732307441	13.6	-12	70	41	117
1732305642	13.6	-12	70	42	117
1732303841	13.6	-10	71	42	117
1732302040	13.5	-10	71	42	117
1732300241	13.4	-8	71	42	117
1732298442	13.3	-10	71	42	117
1732296640	13.2	-12	70	42	117
1732294842	13.1	-12	70	41	117
1732293040	13.1	-12	70	41	117
1732291241	13	-14	70	41	117
1732289441	13	-16	69	41	117
1732287643	13	-16	69	41	117
1732285839	13	-16	69	41	116
1732284042	13	-16	69	40	117
1732282239	13	-16	69	41	116
1732280439	13	-16	69	41	116
1732278638	13	-16	69	41	116
1732276839	13	-16	69	41	116
1732275040	13	-18	69	41	117
1732273239	13	-18	69	41	116
1732271438	13.1	-16	69	41	116
1732269644	13.1	-16	69	41	117
1732267841	13.1	-16	69	41	117
1732266041	13.1	-16	69	41	117
1732264238	13.1	-16	69	41	116

*Used Equation Coefficients:

Value1: 0, 1, 0

Value2: 0, 1, 0

Value3: 0, 1, 0

Value4: 0, 1, 0

Value5: 0, 1, 0

The parameter names for the analog channels will be Value1, Value2, Value3 (up to Value5) if station has not sent a PARAM-packet that specifies the parameter names for each analog channel.
Each analog value is a decimal number between 000 and 255 (according to APRS specifications). The receiver use the telemetry equation coefficientsto to restore the original sensor values. If no EQNS-packet with equation coefficients is sent we will show the values as is (this corresponds to the equation coefficients a=0, b=1 and c=0).
The sent equation coefficients is used in the equation: a * value² + b * value + c.
The units for the analog values will not be shown if station has not sent a UNIT-packet specifying what unit's to use.
The parameter names for the digital bits will be Bit1, Bit2, Bit3 (up to Bit8) if station has not sent a PARAM-packet that specifies the parameter names for each digital bit.
All bit labels will be named "On" if station has not sent a UNIT-packet that specifies the label of each bit.
A bit is considered to be On when the bit is 1 if station has not sent a BITS-packet that specifies another "Bit sense" (a BITS-packet specify the state of the bits that match the BIT labels)