APRS Track Direct

My position About ☰

reset

LW2DHT-2 Telemetry

This is the latest recevied telemetry packets stored in our database for station/object LW2DHT-2. If no packets are shown the sender has not sent any telemetry packets the latest 1 day(s).

Telemetry packets is used to share measurements like repeteater parameters, battery voltage, radiation readings (or any other measurements).

Time	TX*	RX*	Digi*
1782510876	138 Count	120 Count	105 Count
1782509072	128 Count	111 Count	96 Count
1782507269	123 Count	107 Count	92 Count
1782505465	117 Count	102 Count	87 Count
1782503661	112 Count	97 Count	83 Count
1782501858	108 Count	93 Count	80 Count
1782498291	96 Count	86 Count	74 Count
1782496488	92 Count	82 Count	71 Count
1782494684	87 Count	77 Count	67 Count
1782492880	81 Count	71 Count	62 Count
1782491076	77 Count	67 Count	59 Count
1782489273	73 Count	63 Count	56 Count
1782485665	61 Count	52 Count	46 Count
1782482058	51 Count	44 Count	38 Count
1782480254	46 Count	39 Count	34 Count
1782476687	33 Count	31 Count	27 Count
1782474884	28 Count	26 Count	23 Count
1782473080	22 Count	20 Count	18 Count
1782469473	13 Count	11 Count	11 Count
1782467669	7 Count	6 Count	6 Count
1782465865	3 Count	3 Count	3 Count
1782464061	1002 Count	908 Count	718 Count
1782462258	997 Count	903 Count	714 Count
1782460454	993 Count	899 Count	711 Count
1782458653	988 Count	894 Count	707 Count

*Used Equation Coefficients:

TX: 0, 1, 0

RX: 0, 1, 0

Digi: 0, 1, 0

V_Bat: 0, 0.01, 0

V_Ext: 0, 0.02, 0

The parameter names for the analog channels will be Value1, Value2, Value3 (up to Value5) if station has not sent a PARAM-packet that specifies the parameter names for each analog channel.
Each analog value is a decimal number between 000 and 255 (according to APRS specifications). The receiver use the telemetry equation coefficientsto to restore the original sensor values. If no EQNS-packet with equation coefficients is sent we will show the values as is (this corresponds to the equation coefficients a=0, b=1 and c=0).
The sent equation coefficients is used in the equation: a * value² + b * value + c.
The units for the analog values will not be shown if station has not sent a UNIT-packet specifying what unit's to use.
The parameter names for the digital bits will be Bit1, Bit2, Bit3 (up to Bit8) if station has not sent a PARAM-packet that specifies the parameter names for each digital bit.
All bit labels will be named "On" if station has not sent a UNIT-packet that specifies the label of each bit.
A bit is considered to be On when the bit is 1 if station has not sent a BITS-packet that specifies another "Bit sense" (a BITS-packet specify the state of the bits that match the BIT labels)