APRS Track Direct

My position About ☰

reset

KB7JJG-9 Telemetry

This is the latest recevied telemetry packets stored in our database for station/object KB7JJG-9. If no packets are shown the sender has not sent any telemetry packets the latest 1 day(s).

Telemetry packets is used to share measurements like repeteater parameters, battery voltage, radiation readings (or any other measurements).

Time	Value1*	Value2*	Value3*	Value4*	Value5*
1750170103	121	96	999	272	129
1750169602	121	96	999	271	128
1750169101	121	96	999	271	129
1750168601	121	96	999	270	126
1750168099	121	96	999	256	123
1750167592	121	96	999	260	127
1750167091	121	96	999	257	124
1750166587	121	96	999	269	125
1750166086	121	96	999	270	127
1750165585	121	96	999	258	126
1750165084	121	96	999	259	125
1750164583	121	97	999	258	126
1750164082	121	97	999	258	125
1750163080	121	97	999	258	125
1750162078	121	97	999	254	121
1750161575	121	97	999	268	125
1750161073	121	97	999	264	121
1750160071	121	98	999	267	124
1750159570	121	98	999	266	124
1750159069	121	98	999	259	121
1750158568	121	98	999	266	123
1750158096	122	99	999	261	118
1750158082	122	99	999	263	121
1750158067	121	98	999	265	123

*Used Equation Coefficients:

Value1: 0, 1, 0

Value2: 0, 1, 0

Value3: 0, 1, 0

Value4: 0, 1, 0

Value5: 0, 1, 0

The parameter names for the analog channels will be Value1, Value2, Value3 (up to Value5) if station has not sent a PARAM-packet that specifies the parameter names for each analog channel.
Each analog value is a decimal number between 000 and 255 (according to APRS specifications). The receiver use the telemetry equation coefficientsto to restore the original sensor values. If no EQNS-packet with equation coefficients is sent we will show the values as is (this corresponds to the equation coefficients a=0, b=1 and c=0).
The sent equation coefficients is used in the equation: a * value² + b * value + c.
The units for the analog values will not be shown if station has not sent a UNIT-packet specifying what unit's to use.
The parameter names for the digital bits will be Bit1, Bit2, Bit3 (up to Bit8) if station has not sent a PARAM-packet that specifies the parameter names for each digital bit.
All bit labels will be named "On" if station has not sent a UNIT-packet that specifies the label of each bit.
A bit is considered to be On when the bit is 1 if station has not sent a BITS-packet that specifies another "Bit sense" (a BITS-packet specify the state of the bits that match the BIT labels)