APRS Track Direct

My position About ☰

reset

SQ9SXN-10 Telemetry

This is the latest recevied telemetry packets stored in our database for station/object SQ9SXN-10. If no packets are shown the sender has not sent any telemetry packets the latest 1 day(s).

Telemetry packets is used to share measurements like repeteater parameters, battery voltage, radiation readings (or any other measurements).

<< 1 2 >>

Time	TX*	RX*	Digi*
1778021461	723 Count	389 Count	387 Count
1778019661	721 Count	389 Count	387 Count
1778017860	720 Count	389 Count	387 Count
1778016065	718 Count	389 Count	387 Count
1778014259	717 Count	389 Count	387 Count
1778012458	705 Count	379 Count	377 Count
1778010657	675 Count	350 Count	348 Count
1778008856	645 Count	322 Count	320 Count
1778007056	625 Count	303 Count	301 Count
1778005262	620 Count	300 Count	298 Count
1778003462	591 Count	272 Count	270 Count
1778001661	585 Count	268 Count	266 Count
1777999860	584 Count	268 Count	266 Count
1777998059	582 Count	268 Count	266 Count
1777996258	581 Count	268 Count	266 Count
1777994458	579 Count	268 Count	266 Count
1777992657	578 Count	268 Count	266 Count
1777990856	561 Count	253 Count	251 Count
1777989055	530 Count	223 Count	221 Count
1777987255	499 Count	194 Count	192 Count
1777985454	469 Count	165 Count	163 Count
1777984745	468 Count	165 Count	163 Count
1777982945	467 Count	165 Count	163 Count
1777981144	465 Count	165 Count	163 Count
1777979343	464 Count	165 Count	163 Count

*Used Equation Coefficients:

TX: 0, 1, 0

RX: 0, 1, 0

Digi: 0, 1, 0

V_Bat: 0, 0.01, 0

V_Ext: 0, 0.02, 0

The parameter names for the analog channels will be Value1, Value2, Value3 (up to Value5) if station has not sent a PARAM-packet that specifies the parameter names for each analog channel.
Each analog value is a decimal number between 000 and 255 (according to APRS specifications). The receiver use the telemetry equation coefficientsto to restore the original sensor values. If no EQNS-packet with equation coefficients is sent we will show the values as is (this corresponds to the equation coefficients a=0, b=1 and c=0).
The sent equation coefficients is used in the equation: a * value² + b * value + c.
The units for the analog values will not be shown if station has not sent a UNIT-packet specifying what unit's to use.
The parameter names for the digital bits will be Bit1, Bit2, Bit3 (up to Bit8) if station has not sent a PARAM-packet that specifies the parameter names for each digital bit.
All bit labels will be named "On" if station has not sent a UNIT-packet that specifies the label of each bit.
A bit is considered to be On when the bit is 1 if station has not sent a BITS-packet that specifies another "Bit sense" (a BITS-packet specify the state of the bits that match the BIT labels)