APRS Track Direct

My position About ☰

reset

PY2TGD-10 Telemetry

This is the latest recevied telemetry packets stored in our database for station/object PY2TGD-10. If no packets are shown the sender has not sent any telemetry packets the latest 1 day(s).

Telemetry packets is used to share measurements like repeteater parameters, battery voltage, radiation readings (or any other measurements).

Time	CPUTemp*	Uptime*	Injected*
1786733892	54.5 degC	6 days	1260 pkt
1786730288	56 degC	6 days	1260 pkt
1786726685	57 degC	6 days	1260 pkt
1786723082	60 degC	6 days	1260 pkt
1786719478	58.5 degC	6 days	1260 pkt
1786715875	64.5 degC	6 days	1260 pkt
1786712272	64.5 degC	6 days	1260 pkt
1786708669	62 degC	6 days	1260 pkt
1786705066	53 degC	6 days	1260 pkt
1786701462	54 degC	6 days	1260 pkt
1786697859	53 degC	6 days	1260 pkt
1786694246	53.5 degC	6 days	1260 pkt
1786690643	53.5 degC	6 days	1260 pkt
1786687039	55 degC	6 days	1260 pkt
1786683436	55 degC	6 days	1250 pkt
1786679833	53.5 degC	6 days	1250 pkt
1786676230	55 degC	6 days	1250 pkt
1786672627	55.5 degC	6 days	1240 pkt
1786669023	57.5 degC	6 days	1240 pkt
1786665420	63 degC	6 days	1250 pkt
1786661817	54.5 degC	6 days	1250 pkt
1786658214	57 degC	6 days	1250 pkt
1786654611	57 degC	6 days	1210 pkt

*Used Equation Coefficients:

CPUTemp: 0, 0.5, 0

Uptime: 0, 1, 0

Injected: 0, 10, 0

InjRate: 0, 1, 0

Value5: 0, 1, 0

The parameter names for the analog channels will be Value1, Value2, Value3 (up to Value5) if station has not sent a PARAM-packet that specifies the parameter names for each analog channel.
Each analog value is a decimal number between 000 and 255 (according to APRS specifications). The receiver use the telemetry equation coefficientsto to restore the original sensor values. If no EQNS-packet with equation coefficients is sent we will show the values as is (this corresponds to the equation coefficients a=0, b=1 and c=0).
The sent equation coefficients is used in the equation: a * value² + b * value + c.
The units for the analog values will not be shown if station has not sent a UNIT-packet specifying what unit's to use.
The parameter names for the digital bits will be Bit1, Bit2, Bit3 (up to Bit8) if station has not sent a PARAM-packet that specifies the parameter names for each digital bit.
All bit labels will be named "On" if station has not sent a UNIT-packet that specifies the label of each bit.
A bit is considered to be On when the bit is 1 if station has not sent a BITS-packet that specifies another "Bit sense" (a BITS-packet specify the state of the bits that match the BIT labels)