APRS Track Direct

My position About ☰

reset

YB2GKA-13 Telemetry

This is the latest recevied telemetry packets stored in our database for station/object YB2GKA-13. If no packets are shown the sender has not sent any telemetry packets the latest 1 day(s).

Telemetry packets is used to share measurements like repeteater parameters, battery voltage, radiation readings (or any other measurements).

Time	TxTraffic*	RSSI*	Voltage*
1782519358	37 Pkt	-57 dBm	21 V
1782515757	31 Pkt	-61 dBm	18.89 V
1782512662	236 Pkt	-59 dBm	1.37 V
1782511724	242 Pkt	-58 dBm	1.17 V
1782510787	247 Pkt	-57 dBm	1.15 V
1782509849	250 Pkt	-59 dBm	1.31 V
1782508912	230 Pkt	-58 dBm	1.35 V
1782507974	244 Pkt	-60 dBm	1.23 V
1782507031	250 Pkt	-59 dBm	1.17 V
1782506092	241 Pkt	-59 dBm	1.93 V
1782505153	233 Pkt	-58 dBm	1.91 V
1782504215	14 Pkt	-59 dBm	2.03 V
1782503911	231 Pkt	-60 dBm	2.03 V
1782502972	237 Pkt	-60 dBm	1.89 V
1782502034	228 Pkt	-58 dBm	1.83 V
1782501095	221 Pkt	-57 dBm	1.97 V
1782500159	238 Pkt	-57 dBm	1.85 V
1782499220	225 Pkt	-58 dBm	1.93 V
1782498282	241 Pkt	-57 dBm	1.97 V
1782497344	262 Pkt	-58 dBm	1.85 V

*Used Equation Coefficients:

RxTraffic: 0, 1, 0

TxTraffic: 0, 1, 0

RxDrop: 0, 1, 0

RSSI: 0, -1, 0

Voltage: 0, 1, 0

The parameter names for the analog channels will be Value1, Value2, Value3 (up to Value5) if station has not sent a PARAM-packet that specifies the parameter names for each analog channel.
Each analog value is a decimal number between 000 and 255 (according to APRS specifications). The receiver use the telemetry equation coefficientsto to restore the original sensor values. If no EQNS-packet with equation coefficients is sent we will show the values as is (this corresponds to the equation coefficients a=0, b=1 and c=0).
The sent equation coefficients is used in the equation: a * value² + b * value + c.
The units for the analog values will not be shown if station has not sent a UNIT-packet specifying what unit's to use.
The parameter names for the digital bits will be Bit1, Bit2, Bit3 (up to Bit8) if station has not sent a PARAM-packet that specifies the parameter names for each digital bit.
All bit labels will be named "On" if station has not sent a UNIT-packet that specifies the label of each bit.
A bit is considered to be On when the bit is 1 if station has not sent a BITS-packet that specifies another "Bit sense" (a BITS-packet specify the state of the bits that match the BIT labels)