APRS Track Direct

My position About ☰

reset

SP9KPS-1 Telemetry

This is the latest recevied telemetry packets stored in our database for station/object SP9KPS-1. If no packets are shown the sender has not sent any telemetry packets the latest 1 day(s).

Telemetry packets is used to share measurements like repeteater parameters, battery voltage, radiation readings (or any other measurements).

<< 1 2 >>

Time	TX*	RX*	Digi*
1786729203	16 Count	168 Count	15 Count
1786727402	8 Count	89 Count	8 Count
1786725602	115 Count	1001 Count	105 Count
1786723801	104 Count	914 Count	95 Count
1786722008	92 Count	818 Count	84 Count
1786720208	82 Count	733 Count	75 Count
1786718407	73 Count	641 Count	67 Count
1786716606	60 Count	530 Count	55 Count
1786714805	51 Count	449 Count	47 Count
1786713004	37 Count	351 Count	34 Count
1786711204	28 Count	267 Count	26 Count
1786709403	21 Count	165 Count	20 Count
1786707602	12 Count	87 Count	12 Count
1786705801	108 Count	1032 Count	98 Count
1786704001	98 Count	950 Count	89 Count
1786702200	89 Count	848 Count	81 Count
1786700408	81 Count	772 Count	74 Count
1786698607	72 Count	684 Count	66 Count
1786696806	63 Count	605 Count	58 Count
1786695005	49 Count	503 Count	45 Count
1786693205	35 Count	405 Count	32 Count
1786691404	24 Count	294 Count	22 Count
1786689603	16 Count	195 Count	15 Count
1786687802	8 Count	90 Count	8 Count
1786686001	111 Count	1014 Count	96 Count

*Used Equation Coefficients:

TX: 0, 1, 0

RX: 0, 1, 0

Digi: 0, 1, 0

V_Bat: 0, 0.01, 0

V_Ext: 0, 0.02, 0

The parameter names for the analog channels will be Value1, Value2, Value3 (up to Value5) if station has not sent a PARAM-packet that specifies the parameter names for each analog channel.
Each analog value is a decimal number between 000 and 255 (according to APRS specifications). The receiver use the telemetry equation coefficientsto to restore the original sensor values. If no EQNS-packet with equation coefficients is sent we will show the values as is (this corresponds to the equation coefficients a=0, b=1 and c=0).
The sent equation coefficients is used in the equation: a * value² + b * value + c.
The units for the analog values will not be shown if station has not sent a UNIT-packet specifying what unit's to use.
The parameter names for the digital bits will be Bit1, Bit2, Bit3 (up to Bit8) if station has not sent a PARAM-packet that specifies the parameter names for each digital bit.
All bit labels will be named "On" if station has not sent a UNIT-packet that specifies the label of each bit.
A bit is considered to be On when the bit is 1 if station has not sent a BITS-packet that specifies another "Bit sense" (a BITS-packet specify the state of the bits that match the BIT labels)