APRS Track Direct

My position About ☰

reset

EA7HQG-10 Telemetry

This is the latest recevied telemetry packets stored in our database for station/object EA7HQG-10. If no packets are shown the sender has not sent any telemetry packets the latest 1 day(s).

Telemetry packets is used to share measurements like repeteater parameters, battery voltage, radiation readings (or any other measurements).

<< 1 2 >>

Time	TX*	RX*	Digi*
1782531811	15 Count	44 Count	14 Count
1782530008	5 Count	18 Count	5 Count
1782528205	326 Count	1019 Count	283 Count
1782526402	321 Count	998 Count	279 Count
1782524599	314 Count	973 Count	273 Count
1782522796	307 Count	953 Count	267 Count
1782520992	299 Count	931 Count	260 Count
1782519189	291 Count	903 Count	253 Count
1782517386	285 Count	879 Count	248 Count
1782515583	279 Count	857 Count	243 Count
1782513817	273 Count	838 Count	238 Count
1782512014	267 Count	819 Count	233 Count
1782510211	262 Count	803 Count	229 Count
1782508408	255 Count	785 Count	223 Count
1782506604	249 Count	769 Count	218 Count
1782504801	242 Count	750 Count	212 Count
1782502998	234 Count	730 Count	205 Count
1782501195	228 Count	712 Count	200 Count
1782499392	222 Count	694 Count	195 Count
1782497589	209 Count	666 Count	183 Count
1782495785	188 Count	631 Count	163 Count
1782493982	182 Count	609 Count	158 Count
1782492216	176 Count	589 Count	153 Count
1782490413	168 Count	565 Count	146 Count
1782488610	160 Count	542 Count	139 Count

*Used Equation Coefficients:

TX: 0, 1, 0

RX: 0, 1, 0

Digi: 0, 1, 0

V_Bat: 0, 0.01, 0

V_Ext: 0, 0.02, 0

The parameter names for the analog channels will be Value1, Value2, Value3 (up to Value5) if station has not sent a PARAM-packet that specifies the parameter names for each analog channel.
Each analog value is a decimal number between 000 and 255 (according to APRS specifications). The receiver use the telemetry equation coefficientsto to restore the original sensor values. If no EQNS-packet with equation coefficients is sent we will show the values as is (this corresponds to the equation coefficients a=0, b=1 and c=0).
The sent equation coefficients is used in the equation: a * value² + b * value + c.
The units for the analog values will not be shown if station has not sent a UNIT-packet specifying what unit's to use.
The parameter names for the digital bits will be Bit1, Bit2, Bit3 (up to Bit8) if station has not sent a PARAM-packet that specifies the parameter names for each digital bit.
All bit labels will be named "On" if station has not sent a UNIT-packet that specifies the label of each bit.
A bit is considered to be On when the bit is 1 if station has not sent a BITS-packet that specifies another "Bit sense" (a BITS-packet specify the state of the bits that match the BIT labels)