APRS Track Direct

My position About ☰

reset

EB3EWQ Telemetry

This is the latest recevied telemetry packets stored in our database for station/object EB3EWQ. If no packets are shown the sender has not sent any telemetry packets the latest 1 day(s).

Telemetry packets is used to share measurements like repeteater parameters, battery voltage, radiation readings (or any other measurements).

<< 1 2 >>

Time	TX*	RX*	Digi*
1778036868	68 Count	52 Count	52 Count
1778035064	63 Count	48 Count	48 Count
1778033261	58 Count	44 Count	44 Count
1778031458	53 Count	40 Count	40 Count
1778029655	48 Count	36 Count	36 Count
1778027851	43 Count	32 Count	32 Count
1778026048	38 Count	28 Count	28 Count
1778024245	33 Count	24 Count	24 Count
1778022442	28 Count	20 Count	20 Count
1778020639	23 Count	16 Count	16 Count
1778018835	18 Count	12 Count	12 Count
1778017032	13 Count	8 Count	8 Count
1778015264	4 Count	4 Count	4 Count
1778013460	1001 Count	935 Count	824 Count
1778011657	996 Count	931 Count	820 Count
1778009854	991 Count	927 Count	816 Count
1778008050	985 Count	916 Count	811 Count
1778006247	981 Count	913 Count	808 Count
1778004444	978 Count	911 Count	806 Count
1778002641	974 Count	908 Count	803 Count
1778000837	969 Count	904 Count	799 Count
1777999034	964 Count	900 Count	795 Count
1777997231	959 Count	896 Count	791 Count
1777995427	945 Count	883 Count	778 Count
1777993660	937 Count	880 Count	775 Count

*Used Equation Coefficients:

TX: 0, 1, 0

RX: 0, 1, 0

Digi: 0, 1, 0

V_Bat: 0, 0.01, 0

V_Ext: 0, 0.02, 0

The parameter names for the analog channels will be Value1, Value2, Value3 (up to Value5) if station has not sent a PARAM-packet that specifies the parameter names for each analog channel.
Each analog value is a decimal number between 000 and 255 (according to APRS specifications). The receiver use the telemetry equation coefficientsto to restore the original sensor values. If no EQNS-packet with equation coefficients is sent we will show the values as is (this corresponds to the equation coefficients a=0, b=1 and c=0).
The sent equation coefficients is used in the equation: a * value² + b * value + c.
The units for the analog values will not be shown if station has not sent a UNIT-packet specifying what unit's to use.
The parameter names for the digital bits will be Bit1, Bit2, Bit3 (up to Bit8) if station has not sent a PARAM-packet that specifies the parameter names for each digital bit.
All bit labels will be named "On" if station has not sent a UNIT-packet that specifies the label of each bit.
A bit is considered to be On when the bit is 1 if station has not sent a BITS-packet that specifies another "Bit sense" (a BITS-packet specify the state of the bits that match the BIT labels)