APRS Track Direct

☰

reset

W6CX-15 Telemetry

This is the latest recevied telemetry packets stored in our database for station/object W6CX-15. If no packets are shown the sender has not sent any telemetry packets the latest 1 day(s).

Telemetry packets is used to share measurements like repeteater parameters, battery voltage, radiation readings (or any other measurements).

<< 1 2 >>

Time	Value1*	Value2*	Value3*	Value4*	Value5*
1792211904	146	97	128	103	85
1792211303	146	98	128	103	84
1792210102	142	99	127	103	84
1792209500	146	100	127	103	84
1792208899	146	101	127	102	83
1792208298	146	101	127	102	83
1792207072	146	102	127	102	83
1792206471	146	103	127	102	82
1792205872	146	103	127	102	82
1792204669	145	104	127	101	81
1792204067	138	106	127	101	81
1792202866	144	106	127	101	81
1792201663	146	107	127	100	80
1792201063	146	108	127	100	80
1792200461	146	108	127	100	80
1792198658	146	110	127	100	79
1792198057	144	109	127	100	79
1792196856	136	109	126	100	79
1792196255	119	109	126	100	79
1792195053	136	109	126	99	79
1792194452	137	109	126	100	79
1792193851	136	109	126	100	79
1792192607	136	110	126	99	79
1792192006	136	110	126	99	79
1792191405	127	110	126	99	79

*Used Equation Coefficients:

Value1: 0, 1, 0

Value2: 0, 1, 0

Value3: 0, 1, 0

Value4: 0, 1, 0

Value5: 0, 1, 0

The parameter names for the analog channels will be Value1, Value2, Value3 (up to Value5) if station has not sent a PARAM-packet that specifies the parameter names for each analog channel.
Each analog value is a decimal number between 000 and 255 (according to APRS specifications). The receiver use the telemetry equation coefficientsto to restore the original sensor values. If no EQNS-packet with equation coefficients is sent we will show the values as is (this corresponds to the equation coefficients a=0, b=1 and c=0).
The sent equation coefficients is used in the equation: a * value² + b * value + c.
The units for the analog values will not be shown if station has not sent a UNIT-packet specifying what unit's to use.
The parameter names for the digital bits will be Bit1, Bit2, Bit3 (up to Bit8) if station has not sent a PARAM-packet that specifies the parameter names for each digital bit.
All bit labels will be named "On" if station has not sent a UNIT-packet that specifies the label of each bit.
A bit is considered to be On when the bit is 1 if station has not sent a BITS-packet that specifies another "Bit sense" (a BITS-packet specify the state of the bits that match the BIT labels)

Maintained by UW0WU-1, based on APRS Track Direct