APRS Track Direct

My position About ☰

reset

SP9LJE-10 Telemetry

This is the latest recevied telemetry packets stored in our database for station/object SP9LJE-10. If no packets are shown the sender has not sent any telemetry packets the latest 1 day(s).

Telemetry packets is used to share measurements like repeteater parameters, battery voltage, radiation readings (or any other measurements).

<< 1 2 >>

Time	TX*	RX*	Digi*
1782488675	252 Count	417 Count	232 Count
1782486874	241 Count	398 Count	222 Count
1782485074	230 Count	379 Count	212 Count
1782483274	219 Count	360 Count	202 Count
1782481473	209 Count	341 Count	193 Count
1782479672	197 Count	324 Count	183 Count
1782477871	186 Count	304 Count	173 Count
1782476078	175 Count	285 Count	163 Count
1782474277	164 Count	265 Count	153 Count
1782472476	154 Count	247 Count	144 Count
1782470676	122 Count	206 Count	113 Count
1782468875	111 Count	187 Count	103 Count
1782467074	100 Count	168 Count	93 Count
1782463473	78 Count	133 Count	73 Count
1782461673	67 Count	116 Count	63 Count
1782459872	56 Count	97 Count	53 Count
1782458071	45 Count	79 Count	43 Count
1782456271	29 Count	55 Count	28 Count
1782450876	625 Count	896 Count	580 Count
1782449075	572 Count	731 Count	528 Count
1782447275	533 Count	625 Count	490 Count
1782443673	506 Count	591 Count	465 Count
1782441873	491 Count	568 Count	451 Count
1782440072	477 Count	551 Count	438 Count
1782438271	461 Count	531 Count	423 Count

*Used Equation Coefficients:

TX: 0, 1, 0

RX: 0, 1, 0

Digi: 0, 1, 0

V_Bat: 0, 0.01, 0

V_Ext: 0, 0.02, 0

The parameter names for the analog channels will be Value1, Value2, Value3 (up to Value5) if station has not sent a PARAM-packet that specifies the parameter names for each analog channel.
Each analog value is a decimal number between 000 and 255 (according to APRS specifications). The receiver use the telemetry equation coefficientsto to restore the original sensor values. If no EQNS-packet with equation coefficients is sent we will show the values as is (this corresponds to the equation coefficients a=0, b=1 and c=0).
The sent equation coefficients is used in the equation: a * value² + b * value + c.
The units for the analog values will not be shown if station has not sent a UNIT-packet specifying what unit's to use.
The parameter names for the digital bits will be Bit1, Bit2, Bit3 (up to Bit8) if station has not sent a PARAM-packet that specifies the parameter names for each digital bit.
All bit labels will be named "On" if station has not sent a UNIT-packet that specifies the label of each bit.
A bit is considered to be On when the bit is 1 if station has not sent a BITS-packet that specifies another "Bit sense" (a BITS-packet specify the state of the bits that match the BIT labels)