APRS Track Direct

My position About ☰

reset

LD6LF Telemetry

This is the latest recevied telemetry packets stored in our database for station/object LD6LF. If no packets are shown the sender has not sent any telemetry packets the latest 1 day(s).

Telemetry packets is used to share measurements like repeteater parameters, battery voltage, radiation readings (or any other measurements).

Time	Value1*	Value2*	Value3*	Value4*	Value5*
1762324982	151	40	64	43	50
1762320383	151	36	83	43	59
1762315818	151	38	64	43	50
1762311254	151	37	66	43	50
1762306638	151	36	64	43	50
1762302077	151	40	66	43	50
1762297501	151	35	63	43	50
1762292915	151	37	62	43	51
1762288308	150	37	63	43	50
1762283704	151	37	64	43	50
1762279119	150	44	64	43	50
1762274511	151	40	64	43	50
1762269867	151	37	63	43	50
1762265212	151	39	64	46	51
1762260609	151	36	64	43	50
1762255953	151	42	64	68	51
1762251374	150	40	65	75	51
1762246745	151	42	76	43	56
1762242174	151	45	64	43	50

*Used Equation Coefficients:

Value1: 0, 1, 0

Value2: 0, 1, 0

Value3: 0, 1, 0

Value4: 0, 1, 0

Value5: 0, 1, 0

The parameter names for the analog channels will be Value1, Value2, Value3 (up to Value5) if station has not sent a PARAM-packet that specifies the parameter names for each analog channel.
Each analog value is a decimal number between 000 and 255 (according to APRS specifications). The receiver use the telemetry equation coefficientsto to restore the original sensor values. If no EQNS-packet with equation coefficients is sent we will show the values as is (this corresponds to the equation coefficients a=0, b=1 and c=0).
The sent equation coefficients is used in the equation: a * value² + b * value + c.
The units for the analog values will not be shown if station has not sent a UNIT-packet specifying what unit's to use.
The parameter names for the digital bits will be Bit1, Bit2, Bit3 (up to Bit8) if station has not sent a PARAM-packet that specifies the parameter names for each digital bit.
All bit labels will be named "On" if station has not sent a UNIT-packet that specifies the label of each bit.
A bit is considered to be On when the bit is 1 if station has not sent a BITS-packet that specifies another "Bit sense" (a BITS-packet specify the state of the bits that match the BIT labels)