APRS Track Direct

My position About ☰

reset

WA6ODP-15 Telemetry

This is the latest recevied telemetry packets stored in our database for station/object WA6ODP-15. If no packets are shown the sender has not sent any telemetry packets the latest 1 day(s).

Telemetry packets is used to share measurements like repeteater parameters, battery voltage, radiation readings (or any other measurements).

<< 1 2 3 4 >>

Time	Value1*	Value2*
1775947669	11.49	68.33
1775947569	11.51	68.33
1775947468	11.49	68.33
1775947370	11.49	69.21
1775947275	11.49	70.09
1775947151	11.49	68.33
1775946858	11.51	68.33
1775946758	11.51	68.33
1775946659	11.51	69.21
1775946561	11.51	67.45
1775946463	11.51	67.45
1775946364	11.51	67.45
1775946269	11.51	67.45
1775946079	11.51	67.45
1775945984	11.54	67.45
1775945889	11.54	66.57
1775945794	11.54	66.57
1775945700	11.54	66.57
1775945510	11.54	66.57
1775945415	11.54	66.57
1775945320	11.54	65.69
1775945225	11.54	65.69
1775945129	11.54	65.69
1775945034	11.54	65.69
1775944940	11.54	65.69

*Used Equation Coefficients:

Value1: 0, 0.0293, 0

Value2: 0, 0.88, -459.67

Value3: 0, 1, 0

Value4: 0, 1, 0

Value5: 0, 1, 0

The parameter names for the analog channels will be Value1, Value2, Value3 (up to Value5) if station has not sent a PARAM-packet that specifies the parameter names for each analog channel.
Each analog value is a decimal number between 000 and 255 (according to APRS specifications). The receiver use the telemetry equation coefficientsto to restore the original sensor values. If no EQNS-packet with equation coefficients is sent we will show the values as is (this corresponds to the equation coefficients a=0, b=1 and c=0).
The sent equation coefficients is used in the equation: a * value² + b * value + c.
The units for the analog values will not be shown if station has not sent a UNIT-packet specifying what unit's to use.
The parameter names for the digital bits will be Bit1, Bit2, Bit3 (up to Bit8) if station has not sent a PARAM-packet that specifies the parameter names for each digital bit.
All bit labels will be named "On" if station has not sent a UNIT-packet that specifies the label of each bit.
A bit is considered to be On when the bit is 1 if station has not sent a BITS-packet that specifies another "Bit sense" (a BITS-packet specify the state of the bits that match the BIT labels)