APRS Track Direct

My position About ☰

reset

WA6ODP-11 Telemetry

This is the latest recevied telemetry packets stored in our database for station/object WA6ODP-11. If no packets are shown the sender has not sent any telemetry packets the latest 1 day(s).

Telemetry packets is used to share measurements like repeteater parameters, battery voltage, radiation readings (or any other measurements).

<< 1 2 3 >>

Time	Value1*	Value2*
1775953994	11.93	67.45
1775953900	11.9	67.45
1775953806	11.87	67.45
1775953623	11.9	67.45
1775953439	11.9	67.45
1775953347	11.93	67.45
1775953255	11.93	67.45
1775953150	11.93	67.45
1775952963	11.93	67.45
1775952435	11.95	69.21
1775952327	11.98	69.21
1775952120	11.98	70.97
1775951432	12.01	70.09
1775951330	12.04	70.09
1775951229	12.04	70.09
1775951127	12.04	70.97
1775951025	12.04	70.09
1775950923	12.04	70.97
1775950612	12.07	70.97
1775949198	12.1	76.25
1775949106	12.16	77.13
1775948920	12.13	78.89
1775948551	12.16	81.53
1775948459	12.16	82.41
1775948367	12.16	82.41

*Used Equation Coefficients:

Value1: 0, 0.0293, 0

Value2: 0, 0.88, -459.67

Value3: 0, 1, 0

Value4: 0, 1, 0

Value5: 0, 1, 0

The parameter names for the analog channels will be Value1, Value2, Value3 (up to Value5) if station has not sent a PARAM-packet that specifies the parameter names for each analog channel.
Each analog value is a decimal number between 000 and 255 (according to APRS specifications). The receiver use the telemetry equation coefficientsto to restore the original sensor values. If no EQNS-packet with equation coefficients is sent we will show the values as is (this corresponds to the equation coefficients a=0, b=1 and c=0).
The sent equation coefficients is used in the equation: a * value² + b * value + c.
The units for the analog values will not be shown if station has not sent a UNIT-packet specifying what unit's to use.
The parameter names for the digital bits will be Bit1, Bit2, Bit3 (up to Bit8) if station has not sent a PARAM-packet that specifies the parameter names for each digital bit.
All bit labels will be named "On" if station has not sent a UNIT-packet that specifies the label of each bit.
A bit is considered to be On when the bit is 1 if station has not sent a BITS-packet that specifies another "Bit sense" (a BITS-packet specify the state of the bits that match the BIT labels)