APRS Track Direct

My position About ☰

reset

LZ3NF-WX Telemetry

This is the latest recevied telemetry packets stored in our database for station/object LZ3NF-WX. If no packets are shown the sender has not sent any telemetry packets the latest 1 day(s).

Telemetry packets is used to share measurements like repeteater parameters, battery voltage, radiation readings (or any other measurements).

<< 1 2 3 4 >>

Time	WIFI*	VBAT*
1754086174	78 %	16.62 V
1754085574	80 %	14.07 V
1754084975	78 %	15.5 V
1754084374	78 %	4.87 V
1754083775	80 %	15.35 V
1754083174	78 %	16.03 V
1754082575	80 %	15.19 V
1754081975	78 %	15.45 V
1754081374	80 %	15.09 V
1754080775	78 %	16.23 V
1754080174	78 %	15.01 V
1754079575	78 %	13.6 V
1754078974	76 %	16.61 V
1754078374	78 %	15.23 V
1754077775	78 %	15.7 V
1754077174	80 %	4.22 V
1754076572	76 %	15.02 V
1754075972	76 %	16.1 V
1754075372	80 %	15.07 V
1754074773	76 %	14.97 V
1754074172	80 %	16.33 V
1754073572	78 %	4.51 V
1754072971	74 %	15.01 V
1754072369	78 %	16.35 V
1754071769	78 %	14.9 V

*Used Equation Coefficients:

WIFI: 0, 1, 0

VBAT: 0, 0.01, 0

Value3: 0, 0, 0

Value4: 0, 0, 0

Value5: 0, 0, 0

The parameter names for the analog channels will be Value1, Value2, Value3 (up to Value5) if station has not sent a PARAM-packet that specifies the parameter names for each analog channel.
Each analog value is a decimal number between 000 and 255 (according to APRS specifications). The receiver use the telemetry equation coefficientsto to restore the original sensor values. If no EQNS-packet with equation coefficients is sent we will show the values as is (this corresponds to the equation coefficients a=0, b=1 and c=0).
The sent equation coefficients is used in the equation: a * value² + b * value + c.
The units for the analog values will not be shown if station has not sent a UNIT-packet specifying what unit's to use.
The parameter names for the digital bits will be Bit1, Bit2, Bit3 (up to Bit8) if station has not sent a PARAM-packet that specifies the parameter names for each digital bit.
All bit labels will be named "On" if station has not sent a UNIT-packet that specifies the label of each bit.
A bit is considered to be On when the bit is 1 if station has not sent a BITS-packet that specifies another "Bit sense" (a BITS-packet specify the state of the bits that match the BIT labels)