APRS Track Direct

My position About ☰

reset

YM4KCA Telemetry

This is the latest recevied telemetry packets stored in our database for station/object YM4KCA. If no packets are shown the sender has not sent any telemetry packets the latest 1 day(s).

Telemetry packets is used to share measurements like repeteater parameters, battery voltage, radiation readings (or any other measurements).

Time	RSSI*	Voltage*
1753938669	31 dBm	14.07 V
1753934059	31 dBm	13.41 V
1753926683	31 dBm	12.86 V
1753918385	31 dBm	12.9 V
1753916541	31 dBm	12.94 V
1753915619	31 dBm	12.96 V
1753909165	31 dBm	12.98 V
1753907321	31 dBm	12.98 V
1753905477	31 dBm	13 V
1753900867	31 dBm	13.04 V
1753899945	31 dBm	13.04 V
1753899023	31 dBm	13.04 V
1753894413	31 dBm	13.7 V
1753892570	31 dBm	13.6 V
1753886070	31 dBm	13.7 V
1753885148	31 dBm	13.68 V
1753876850	31 dBm	13.68 V
1753875928	31 dBm	13.7 V
1753873162	31 dBm	13.68 V
1753867630	31 dBm	13.68 V
1753866708	31 dBm	13.68 V
1753864864	31 dBm	13.68 V
1753863020	31 dBm	13.68 V
1753859332	31 dBm	13.9 V
1753855644	31 dBm	14.15 V

*Used Equation Coefficients:

RxTraffic: 0, 1, 0

TxTraffic: 0, 1, 0

RxDrop: 0, 1, 0

RSSI: 0, -1, 0

Voltage: 0, 1, 0

The parameter names for the analog channels will be Value1, Value2, Value3 (up to Value5) if station has not sent a PARAM-packet that specifies the parameter names for each analog channel.
Each analog value is a decimal number between 000 and 255 (according to APRS specifications). The receiver use the telemetry equation coefficientsto to restore the original sensor values. If no EQNS-packet with equation coefficients is sent we will show the values as is (this corresponds to the equation coefficients a=0, b=1 and c=0).
The sent equation coefficients is used in the equation: a * value² + b * value + c.
The units for the analog values will not be shown if station has not sent a UNIT-packet specifying what unit's to use.
The parameter names for the digital bits will be Bit1, Bit2, Bit3 (up to Bit8) if station has not sent a PARAM-packet that specifies the parameter names for each digital bit.
All bit labels will be named "On" if station has not sent a UNIT-packet that specifies the label of each bit.
A bit is considered to be On when the bit is 1 if station has not sent a BITS-packet that specifies another "Bit sense" (a BITS-packet specify the state of the bits that match the BIT labels)