APRS Track Direct

My position About ☰

reset

K1OSH-15 Telemetry

This is the latest recevied telemetry packets stored in our database for station/object K1OSH-15. If no packets are shown the sender has not sent any telemetry packets the latest 1 day(s).

Telemetry packets is used to share measurements like repeteater parameters, battery voltage, radiation readings (or any other measurements).

<< 1 2 3 4 >>

Time	Value1*	Value2*	Value3*	Value4*	Value5*
1786743686	137	96	255	80	54
1786743084	137	97	255	79	53
1786741881	137	101	255	77	52
1786741280	137	104	255	76	49
1786740678	137	105	255	74	48
1786740077	137	108	255	72	47
1786739475	137	111	255	71	45
1786738272	137	112	255	70	43
1786737670	137	112	255	69	43
1786736467	137	112	255	69	44
1786735264	137	112	255	70	44
1786734061	137	111	255	70	44
1786732256	137	110	255	71	45
1786729850	137	104	255	74	48
1786728647	135	100	255	77	52
1786727444	137	96	255	80	55
1786726842	137	93	255	82	56
1786725639	137	87	255	85	60
1786725038	137	84	255	87	62
1786723233	137	76	255	92	68
1786722030	137	73	255	94	71
1786721429	137	72	255	94	72
1786719624	142	68	255	97	73
1786719023	142	68	255	97	75
1786718421	142	67	255	97	75

*Used Equation Coefficients:

Value1: 0, 1, 0

Value2: 0, 1, 0

Value3: 0, 1, 0

Value4: 0, 1, 0

Value5: 0, 1, 0

The parameter names for the analog channels will be Value1, Value2, Value3 (up to Value5) if station has not sent a PARAM-packet that specifies the parameter names for each analog channel.
Each analog value is a decimal number between 000 and 255 (according to APRS specifications). The receiver use the telemetry equation coefficientsto to restore the original sensor values. If no EQNS-packet with equation coefficients is sent we will show the values as is (this corresponds to the equation coefficients a=0, b=1 and c=0).
The sent equation coefficients is used in the equation: a * value² + b * value + c.
The units for the analog values will not be shown if station has not sent a UNIT-packet specifying what unit's to use.
The parameter names for the digital bits will be Bit1, Bit2, Bit3 (up to Bit8) if station has not sent a PARAM-packet that specifies the parameter names for each digital bit.
All bit labels will be named "On" if station has not sent a UNIT-packet that specifies the label of each bit.
A bit is considered to be On when the bit is 1 if station has not sent a BITS-packet that specifies another "Bit sense" (a BITS-packet specify the state of the bits that match the BIT labels)