APRS Track Direct

My position About ☰

reset

VK2YMI-9 Telemetry

This is the latest recevied telemetry packets stored in our database for station/object VK2YMI-9. If no packets are shown the sender has not sent any telemetry packets the latest 1 day(s).

Telemetry packets is used to share measurements like repeteater parameters, battery voltage, radiation readings (or any other measurements).

Time	Value1*	Value2*	Value3*	Value4*	Value5*
1753578689	103	130	255	100	78
1753578600	113	130	255	101	79
1753578580	113	130	255	100	78
1753578517	115	130	255	105	81
1753578508	113	130	255	101	78
1753578478	113	130	255	100	78
1753578219	114	130	255	101	78
1753578157	114	130	255	102	79
1753578132	114	130	255	102	79
1753578040	115	130	255	101	79
1753577909	114	130	255	102	79
1753577823	114	130	255	102	80
1753577766	116	130	255	102	80
1753576817	115	130	255	109	85
1753576811	116	130	255	104	81
1753570406	108	130	255	103	81
1753570167	116	129	255	103	81
1753569907	116	129	255	108	86
1753569901	117	129	255	103	82
1753569871	116	129	255	104	83
1753569854	116	129	255	103	82
1753569733	118	129	255	103	82
1753569625	117	129	255	103	82
1753569504	116	129	255	108	87
1753569497	117	129	255	102	82

*Used Equation Coefficients:

Value1: 0, 1, 0

Value2: 0, 1, 0

Value3: 0, 1, 0

Value4: 0, 1, 0

Value5: 0, 1, 0

The parameter names for the analog channels will be Value1, Value2, Value3 (up to Value5) if station has not sent a PARAM-packet that specifies the parameter names for each analog channel.
Each analog value is a decimal number between 000 and 255 (according to APRS specifications). The receiver use the telemetry equation coefficientsto to restore the original sensor values. If no EQNS-packet with equation coefficients is sent we will show the values as is (this corresponds to the equation coefficients a=0, b=1 and c=0).
The sent equation coefficients is used in the equation: a * value² + b * value + c.
The units for the analog values will not be shown if station has not sent a UNIT-packet specifying what unit's to use.
The parameter names for the digital bits will be Bit1, Bit2, Bit3 (up to Bit8) if station has not sent a PARAM-packet that specifies the parameter names for each digital bit.
All bit labels will be named "On" if station has not sent a UNIT-packet that specifies the label of each bit.
A bit is considered to be On when the bit is 1 if station has not sent a BITS-packet that specifies another "Bit sense" (a BITS-packet specify the state of the bits that match the BIT labels)