APRS Track Direct

My position About ☰

reset

IU5MGF-10 Telemetry

This is the latest recevied telemetry packets stored in our database for station/object IU5MGF-10. If no packets are shown the sender has not sent any telemetry packets the latest 1 day(s).

Telemetry packets is used to share measurements like repeteater parameters, battery voltage, radiation readings (or any other measurements).

<< 1 2 3 >>

Time	TX*	RX*	Digi*
1775313888	140 Count	772 Count	66 Count
1775312084	137 Count	756 Count	64 Count
1775310280	133 Count	725 Count	61 Count
1775303066	108 Count	621 Count	40 Count
1775301262	98 Count	604 Count	31 Count
1775299459	94 Count	583 Count	28 Count
1775297655	91 Count	565 Count	26 Count
1775295852	88 Count	534 Count	24 Count
1775295074	87 Count	534 Count	24 Count
1775295061	86 Count	534 Count	24 Count
1775295043	85 Count	534 Count	24 Count
1775292639	82 Count	510 Count	23 Count
1775290834	79 Count	494 Count	21 Count
1775289030	76 Count	470 Count	19 Count
1775288906	75 Count	470 Count	19 Count
1775287513	74 Count	470 Count	19 Count
1775286729	73 Count	470 Count	19 Count
1775286671	72 Count	470 Count	19 Count
1775286649	71 Count	470 Count	19 Count
1775286455	70 Count	470 Count	19 Count
1775282233	69 Count	470 Count	19 Count
1775280429	65 Count	446 Count	16 Count
1775278625	64 Count	424 Count	16 Count
1775276864	63 Count	403 Count	16 Count
1775275064	62 Count	388 Count	16 Count

*Used Equation Coefficients:

TX: 0, 1, 0

RX: 0, 1, 0

Digi: 0, 1, 0

V_Bat: 0, 0.01, 0

V_Ext: 0, 0.02, 0

The parameter names for the analog channels will be Value1, Value2, Value3 (up to Value5) if station has not sent a PARAM-packet that specifies the parameter names for each analog channel.
Each analog value is a decimal number between 000 and 255 (according to APRS specifications). The receiver use the telemetry equation coefficientsto to restore the original sensor values. If no EQNS-packet with equation coefficients is sent we will show the values as is (this corresponds to the equation coefficients a=0, b=1 and c=0).
The sent equation coefficients is used in the equation: a * value² + b * value + c.
The units for the analog values will not be shown if station has not sent a UNIT-packet specifying what unit's to use.
The parameter names for the digital bits will be Bit1, Bit2, Bit3 (up to Bit8) if station has not sent a PARAM-packet that specifies the parameter names for each digital bit.
All bit labels will be named "On" if station has not sent a UNIT-packet that specifies the label of each bit.
A bit is considered to be On when the bit is 1 if station has not sent a BITS-packet that specifies another "Bit sense" (a BITS-packet specify the state of the bits that match the BIT labels)