APRS Track Direct

My position About ☰

reset

HS1AXC-1 Telemetry

This is the latest recevied telemetry packets stored in our database for station/object HS1AXC-1. If no packets are shown the sender has not sent any telemetry packets the latest 1 day(s).

Telemetry packets is used to share measurements like repeteater parameters, battery voltage, radiation readings (or any other measurements).

<< 1 2 3 4 >>

Time	RSSI*	Voltage*
1732291500	-66 dBm	12.47 V
1732290878	-67 dBm	12.47 V
1732290256	-67 dBm	12.47 V
1732289634	-67 dBm	12.47 V
1732289012	-66 dBm	12.47 V
1732288390	-66 dBm	12.47 V
1732287768	-67 dBm	12.47 V
1732287146	-67 dBm	12.47 V
1732286524	-67 dBm	12.47 V
1732285902	-67 dBm	12.47 V
1732285280	-67 dBm	12.47 V
1732284658	-67 dBm	12.47 V
1732284036	-66 dBm	12.47 V
1732283414	-69 dBm	12.47 V
1732282792	-69 dBm	12.47 V
1732282170	-69 dBm	12.47 V
1732281548	-69 dBm	12.47 V
1732280926	-69 dBm	12.47 V
1732280304	-69 dBm	12.47 V
1732279682	-69 dBm	12.47 V
1732279060	-69 dBm	12.47 V
1732278438	-70 dBm	12.47 V
1732277816	-68 dBm	12.47 V
1732277194	-70 dBm	12.47 V
1732276572	-68 dBm	12.47 V

*Used Equation Coefficients:

RxTraffic: 0, 1, 0

TxTraffic: 0, 1, 0

RxDrop: 0, 1, 0

RSSI: 0, -1, 0

Voltage: 0, 1, 0

The parameter names for the analog channels will be Value1, Value2, Value3 (up to Value5) if station has not sent a PARAM-packet that specifies the parameter names for each analog channel.
Each analog value is a decimal number between 000 and 255 (according to APRS specifications). The receiver use the telemetry equation coefficientsto to restore the original sensor values. If no EQNS-packet with equation coefficients is sent we will show the values as is (this corresponds to the equation coefficients a=0, b=1 and c=0).
The sent equation coefficients is used in the equation: a * value² + b * value + c.
The units for the analog values will not be shown if station has not sent a UNIT-packet specifying what unit's to use.
The parameter names for the digital bits will be Bit1, Bit2, Bit3 (up to Bit8) if station has not sent a PARAM-packet that specifies the parameter names for each digital bit.
All bit labels will be named "On" if station has not sent a UNIT-packet that specifies the label of each bit.
A bit is considered to be On when the bit is 1 if station has not sent a BITS-packet that specifies another "Bit sense" (a BITS-packet specify the state of the bits that match the BIT labels)