APRS Track Direct

My position About ☰

reset

DB0BC-12 Telemetry

This is the latest recevied telemetry packets stored in our database for station/object DB0BC-12. If no packets are shown the sender has not sent any telemetry packets the latest 1 day(s).

Telemetry packets is used to share measurements like repeteater parameters, battery voltage, radiation readings (or any other measurements).

<< 1 2 3 4 >>

Time	Volt*	Ampere*
1775564654	12.6 V	2983 A
1775564649	12.6 V	2983 A
1775562832	12.5 V	4033 A
1775562828	12.5 V	4033 A
1775561017	12.5 V	4007 A
1775561013	12.5 V	4007 A
1775559204	12.5 V	4124 A
1775559198	12.5 V	4124 A
1775557388	12.6 V	2938 A
1775557383	12.6 V	2938 A
1775555571	12.6 V	2831 A
1775555567	12.6 V	2831 A
1775553758	12.5 V	3871 A
1775553752	12.5 V	3871 A
1775551939	12.5 V	3696 A
1775551937	12.5 V	3696 A
1775550126	12.6 V	2833 A
1775550122	12.6 V	2833 A
1775548310	12.6 V	2779 A
1775548307	12.6 V	2779 A
1775546495	12.5 V	4115 A
1775546492	12.5 V	4115 A
1775544678	12.5 V	3726 A
1775544677	12.5 V	3726 A
1775542864	12.5 V	3676 A

*Used Equation Coefficients:

Volt: 0, 1, 0

Ampere: 0, 1, 0

Batt: 0, 1, 0

Value4: 0, 1, 0

Value5: 0, 1, 0

The parameter names for the analog channels will be Value1, Value2, Value3 (up to Value5) if station has not sent a PARAM-packet that specifies the parameter names for each analog channel.
Each analog value is a decimal number between 000 and 255 (according to APRS specifications). The receiver use the telemetry equation coefficientsto to restore the original sensor values. If no EQNS-packet with equation coefficients is sent we will show the values as is (this corresponds to the equation coefficients a=0, b=1 and c=0).
The sent equation coefficients is used in the equation: a * value² + b * value + c.
The units for the analog values will not be shown if station has not sent a UNIT-packet specifying what unit's to use.
The parameter names for the digital bits will be Bit1, Bit2, Bit3 (up to Bit8) if station has not sent a PARAM-packet that specifies the parameter names for each digital bit.
All bit labels will be named "On" if station has not sent a UNIT-packet that specifies the label of each bit.
A bit is considered to be On when the bit is 1 if station has not sent a BITS-packet that specifies another "Bit sense" (a BITS-packet specify the state of the bits that match the BIT labels)